Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Sloping cutting board questions

Posts

Sloping cutting board questions

#1

Sloping cutting board questions

Barry Irby

I have made a cutting board vaguely similar to the one Bill Tindall made. His was square, mine is round and turned on a lathe.

I turned mine with it mounted at and angle so the depression slopes from nothing on one side to about a 1/2" deep on the other. The board is 15" in diameter. The question is, Is that enough?

I'm thinking I need to put it back on the lathe and increase it to 3/4" of slope and maybe have a rim or maybe an 1/8" on the shallow side.

Second question. Why have it slope to one end? It would be easier to just turn a depression into the center. Maybe having the food sit in its own juices would not be appetizing.

Re: Sloping cutting board questions

#2

Correction

Bill Tindall, E.Tn.


a 1/2" deep on the other. The board is 15" in diameter. The question is, Is that enough? ....mine are 3/4" deep. I use it for chopping veggies and the depth is necessary for holding the chopped product.

Second question. Why have it slope to one end?...... Try chopping onions with a chef's knife in a bowl

Re: Sloping cutting board questions

#3

for example

Bill Tindall, E.Tn.

I am cutting up some onions for some venison Goulash today


Re: Sloping cutting board questions

#4

Re: for example

Barry Irby

That looks like a Santoku shaped blade, fairly straight. Some of them and most chef's knives are slightly curved.

What I was thinking of was curving the bottom of the "dish" to match the shape of the blade or slightly flatter.

The one I have now is very similar to yours with the onions, but not as deep.

I have made number rectangular ones that I dished out the center about a 1/4" and left the four corners the original height. There was about an 1/8" arch from corner to corner. this not only help to keep the juices from running of, but broke the suction with the counter top if they did.

Re: Sloping cutting board questions

#5

Re: for example

William Duffield

Just don't curve the bottom more than the curve of your chef's knife. :) That became obvious to me when a regular old flat chopping board warped after a trip through the dish washer.

If you use it for chopping nuts, even 3/4" at the back might not be enough, since most of the trajectories are to the side, where the wall is lower.