Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Springs for Delta #22-540 Planer

Posts

Springs for Delta #22-540 Planer

#1

Springs for Delta #22-540 Planer

Brad Chenoweth

Went to change the blades on my Delta lunchbox planer. One of the small blade springs is toast. Apparently, these springs are a discontinued item from Delta. Their usual product support, at least these days. Anyone had any luck finding replacements? I suppose I could set them without the springs, but they sure make it simpler. I thought of the spring from a pen, but so far everything I've found is too large. The stock springs are .156" diameter.

X 3/8 it so long.

Brad :\

Re: Springs for Delta #22-540 Planer

#2

check here

del schisler

go here http://www.ereplacementparts.com/delta-22540-type-planer-parts-c-3275_3571_3578.html

Re: Springs for Delta #22-540 Planer

#3

Re: check here *LINK*

Bruce, a MN Galoot

You mean the part on eReplacements that says "obsolete?"

First try your local hardware store, not the big box ones. My local Ace carries a lot of springs. Then try Fastenal.

Failing that consider this, starting at the 10:45 point


WaffenschmiedinX

Re: Springs for Delta #22-540 Planer

#4

Re: Springs for Delta #22-540 Planer *LINK*

Bob Entwisle in NJ

Brad,

I googled "Spring 1343868" and this link came up. It looks like they have them in stock for a couple bucks each.

I've no experience with this supplier etc.

There were a number of 'hits' with that google search, so you may have other choices of supplier.

Hope this helps

Bob in NJ


Delta Spring P/N 1343868

Re: Springs for Delta #22-540 Planer

#5

Thanks, Guys!!

Brad Chenoweth

Thanks for the suggestions, fellas! I actually found a spring in our tool crib at the shop that I can cut into 2 or 3 pieces and use. I'm considering placing a couple of rare earth magnets on the 2 flat sections of the setting jig and using those to hold the blades in the proper position. I think that should work OK. Bob, I may order a couple of spares from your source, just in case. Thanks again!

Brad