Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

What to do with butcher block table tops?

Posts

What to do with butcher block table tops?

#1

What to do with butcher block table tops?

Barry Irby

I bought some walnut butcher block table tops at an auction. I have mentioned them here before. I bought them because they were pretty and walnut and needed rescuing. Now I am considering selling them as it has slowly dawned on me I have no real use for them.

I have two that are 30" by 48" by 1 3/4" and two that are 36" by 48" by 1 3/4". The strips in them are basically 1 3/4" square.

I will offer them whole, but I am considering cutting them up into cutting boards. Also considering converting some of the cutting boards into end grain boards. I am thinking they will bring more money as cutting board than as table tops.

The Company that made them said the price on the 36 by 48 was $600. Amazon has similar ones for $400. I am thinking I will be doing well to get $200 for my slightly careworn ones. Cutting boards bring more per square foot and will be easier to ship if necessary.

Any thoughts/suggestions?

Re: What to do with butcher block table tops?

#2

It would be a shame to cut them up *LINK*

Dick Coers

I imagine you got them for the right price, so I'd put just a little more into them and sell them as tables. You can get a 4 pack of steel "hairpin" legs for $60, and then list then on craigslist. Matching coffee table and kitchen table.


http://www.rockler.com/i-sembletrade-hairpin-table-legs

Re: What to do with butcher block table tops?

#3

Agree, and an additional thought...

John in NM

I would look for a restaurant that needs new table tops. It would be a bit of work for you if you found one, but you could turn a great profit on it and still give them an attractive price!

Re: What to do with butcher block table tops?

#4

Whatever you do...

John in NM

Watch out for little corrugated fasteners inside the block. I was just cutting up some surplus maple butcher block top and found a couple with my jointer (new knives too... >( )

These were across two pieces butted on the end grain.