Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Old Power King jig saw

Posts

Old Power King jig saw

#1

Old Power King jig saw

Craig Morley

I'm looking for any info on a 40's-50's Power King jig saw. This has been in the family and I'm putting it back into use. I'd like to know what type of blade is correct, the the proper motor speed and pulley sizes.

Any info would be appreciated. Craig

Re: Old Power King jig saw

#2

Ellis Walentine

Re: Old Power King jig saw

Ellis Walentine

Most likely it came with a 1/4hp, 1725rpm motor. See this entry:

http://www.vintagemachinery.org/photoindex/detail.aspx?id=13478

On the owwm.org forum, here is another entry of possible interest.

http://owwm.org/viewtopic.php?f=1&t=95946&p=655287&hilit=power+king+jig+saw#p655287

The blade is a pin end blade, either 5" or 6", I'm not sure, but that should be easy enough to determine.

I was impressed that this jig saw looked so much like my very first machine, a Sears Craftsman jig saw that my father gave me for my fifth birthday. Then I learned that Power King had indeed manufactured for Sears as well, so I guess I have some experience with this company. I fondly recall all the hours I whiled away in my basement as a kid, cutting out little projects that I copied from gridded patterns in old Deltagrams and "One-Evening Projects" booklets. In retrospect, though, this design for a jig saw is pretty primitive. If I were to get back into scrolling, I'd definitely go with an Excalibur, or at least a DeWalt.

Hope this helps.

Ellis Walentine, Host

Re: Old Power King jig saw

#3

Re: Old Power King jig saw

Craig Morley

Thanks very much for the info fellows, I'll post photos later on. Thanks again for the help.