Re: Festool Domino question *LINK*
Jim Dillon
Bill, yes the manual that comes with the Domino is sketchy to say the least. See the link below for much better guidance. As everything is metric on the Domino, a 6-inch metric ruler is handy to measure the thickness of the wood. I also have a battery powered caliper that I use a lot in metric mode.
"Specifically, what is done to ensure the mating parts line up? Is using the aiming line on the clear plastic part and free handing it sufficient?"
Provided your Domino hasn't been damaged or the plastic guide moved, you can just use it freehand. Procedures for calibrating the scribe line are given in the links below.
"Specifically, what works best to register the tool on the lumber so the mating parts mate perfectly? Can it in fact be used "free hand with the target lines on the clear plastic part to align the machine to a scribe line? Or is it necessary to construct a jig to hold piece to be tenoned and align and fix the machine position? What works best?"
The Domino is so accurate that you indeed can just use the scribe line on the clear plastic part to hand-hold the Domino while you are routing the mortise. You will need to hold down the piece to be mortised somehow which sometimes takes me longer to figure out than routing the mortise. Laying out the mortise location often takes more time that actually cutting the mortise - at least in my hands.
Tip: Make sure you work from only one side of the wood. I usually just put a chalk mark on all the "face" sides. This avoids any slight errors due to setting the placement of the mortise. Have a scrap piece of wood handy to check the placement of the mortise. I find this to be the most time consuming in setting up the Domino.
"Any tips on how to use this thing will be appreciated. So many have recommended it. I now have an opportunity to try it. If it doesn't work for my needs you will see it soon in the classified."
Tip: Make sure you hook up a shop-vac to the Domino to pull the chips out. Try to use a balanced approach when holding the Domino - that is, holding down on the front and rear evenly. Also, don't rush the mortise cutting by pushing the Domino rapidly into the wood as this might jar the Domino a bit. Each mortise only takes 1-2 seconds to cut. Use a slow, steady plunge.
The "zero" setting for the width of the mortise really makes a mortise that allows NO sidewise movement. I generally make a couple of mortises with the zero width setting, the the remainder with the next width setting. You could also adjust the width manually by just moving the Domino a tad away from the scribe line. I do this a lot rather than changing the width on the Domino itself.
I also have used the Domino, instead of a slot cutter, to make slots for ebony inlay in G&G style furniture. Super great for cutting the mortises for breadboards and allowing for expansion at the same time.
The Festool website has several great manuals. The Festool Supplemental Users Manual by Rick Christopherson is great, as is the article by Jerry Work "Getting the most From the Festool Domino Machine" Lots of YouTube videos as well.
Sometimes the Dominos fit just too tight or have swelled a tad due to humidity. Microwaving them a bit or simply sanding on a flat surface solves this problem. An oven bake at low temperature would probably accomplish the same thing.
Have fun and practice on scrap first to get the hang of the Domino.
Hope this helps. I'll probably think of more later. Jim
Festool Manuals