Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Table Saw Outfeedtable design ideas Take 2

Posts

Table Saw Outfeedtable design ideas Take 2

#1

Alan Young

Table Saw Outfeedtable design ideas Take 2

Alan Young

OK Hope I have it right this time!

I've posted pics from my shop before showing pieces at various stages of development. Today's post is about the shop. It's small by many standards. It is a basement shop with a max head space of 7 feet. The headroom is lower in much of the shop as @ 40% of the ceiling is covered by duct work. For years I been putting off installing a dust collection system-justifying my inaction with "Lack of Space and Lack of Funds." I overcame those two objections this week. It began a week ago when I bought this Rikon Air Filtration System


Then Yesterday I headed to my local Harbor Freight outlet and bought their $200 DC.


I bought the HF DC even though it didn't come with hose or fittings to other machines and the store didn't carry any either. I figured a relatively short drive on a nice Sunday afternoon(~15 miles)to the Woodcraft store afterwards would allow me to purchase the hose and the required attachments. So I headed off to woodcraft with a $200 HF DC in the back of my truck. I went to the DC section and began looking for the necessary hoses and attachments- then saw this sweet Laguna Dust Collector.


Although it is more than twice the price than the HF unit -It's foot print and height are significantly less So I bought it and hauled it home with the HF Unit still in the truck. At this point I plan on hooking up the DC to the Table Saw and moving the hose to the Band Saw when necessary. My TS is an early "70's Unisaw. Now the real nitty gritty-My Unisaw has a fold up/down out feed roller. This has to come off before I can attach the hose and adapter.


and even then the brackets cover the opening so If I want to use this again I'll need to relocate the opening and cove the old one-I don't want to do that so I am looking for other adjustable out feed designs that fit in a small space. I must be able to lower the out feed table or move it away completely to get finished pieces out the door that is seen in the back of this photo:


I especially appreciate photos the show your set-ups or ideas-

Thanks

Alan

Re: Table Saw Outfeedtable design ideas Take 2

#2

Re: Table Saw Outfeedtable design ideas Take 2

Jerry Gibbs

Always impressed by the quality of your work. This is especially so given your shop limitations.

Re: Table Saw Outfeedtable design ideas Take 2

#3

Drawer slides *LINK*

Hoa in Alameda

In this article, there are some ideas about using drawer slides for outfeed table:


Table Saw Outfeed Tables

Re: Table Saw Outfeedtable design ideas Take 2

#4

Alan Young

Quick and dirty fix

Alan Young

Made a quick hook up for the DC hose to Table Saw. i found a toilet hub that fit just fine-attached that to a plywood board over the lower opening.


The Roller Extention's lower brace extended past the opening-I just cut it off with a sawzall. So I'm set for now.