Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Wood finishing

Posts

Wood finishing

#1

Wood finishing

Howardd

I'm building a small cabinet out of Baltic birch and want to finish with a white enamal. What would be the best primer to use water base, oil base or shellac base?

I hate finishing and need the most fool proof primer.

Thanks

Howard

Re: Wood finishing

#2

Re: Wood finishing

Mark Mandell - Gone Round In New Jersey

Dewaxed shellac.

Either mix fresh from dry flakes (best) or use Zinnser's SealCoat

Re: Wood finishing

#3

Re: Wood finishing

Bill Tindall, E.Tn.

I use Kilz under paint. It can be sanded glass smooth then painted.

Re: Wood finishing

#4

Re: Wood finishing

Bill Tindall, E.Tn.

Shellac is good for sealer, ineffective for filling. A high solids primer like Kilz will fill in all the pores and leave a glass smooth surface. If I wasn't striving for smooth I would not seal at all....just paint it with paint.

Re: Wood finishing

#5

Re: Wood

Mark Mandell - Gone Round In New Jersey

Howard's working with baltic birch so I don't see the need for pore filling. It appears that he will be hand applying. Kilz will be more work to level and remove brush marks that a light application of shellac.

Re: Wood finishing

#6

Depends on the quality of the plywood

Dick Coers

I've seen good Baltic birch plywood, and I've seen cheap import stock that is as rough as a cob. The rough stuff would benefit greatly from a heavy bodied primer.

Re: Wood finishing

#7

That depends a lot on you,

Keith Newton

and how you intend to apply it. Will you be spraying, and if not what, roller, brush, or corn shuck?

Re: Wood finishing

#8

Guess I'm Spoiled

Mark Mandell - Gone Round In New Jersey

The only BB I've seen looked to have been sanded to 180.

Re: Wood finishing

#9

good point....

Bill Tindall, E.Tn.

"Kilz will be more work to level and remove brush marks " The solvent based Kilz needs thinning to flow well. But it sands easily to glass smooth.

Re: Wood finishing

#10

Re: That depends a lot on you,

Howardd

I will be using a roller

Re: Wood finishing

#11

Re: Wood finishing

TomD

I've used Behr super white Int/Ext over plywood, and other paint grade wood, and I use the Behr primer. It delivers results almost as good as a gloss enamel, and it is easy and safer to work with. I use it on my boat also. I have it right net to plywood that was shot with alwgrip automotive paint and it looks the same and lasts longer. I wouldn't paint my car with it, though. :)

This is all in awlgrip except where I had to make repairs. The boat and trailer are all wood and mostly plywood.


And this is after I painted parts that needed it in white Behr latex. Obviously you can't tell, but frankly, I figured you could tell even from a photo, or a distance. I can't today tell which were painted with which. Except there are some areas that haven't been touched.