Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

"Wax resistant" finish?

Posts

"Wax resistant" finish?

#1

JL

"Wax resistant" finish?

JL

What would you consider to be a reasonable finish that you could easily get wax off of?

Our priest, Liz, wants to use wax candles during Advent as opposed to oil filled candles.

The big problem is that even with bobeches (wax catchers) - some wax gets on the stand that holds the candles. So - what would be a reasonable finish to put on the "ring" that holds the Advent wreath and the Advent candles? I would also be putting the same finish on the stand.

Re: "Wax resistant" finish?

#2

Re: "Wax resistant" finish?

John in NM

Poly would be my choice (oil type, not water soluble). Wax would stick but you could easily remove it with some solvent without damaging the finish. Paint thinner or turpentine to remove the wax.

Re: "Wax resistant" finish?

#4

Glass

Dick Coers

If on the altar, you can put down a full sheet of glass on top, or just a piece under the candles.

Re: "Wax resistant" finish?

#5

Re: "Wax resistant" finish?

Robin Corell in Atascadero

Apply any finish you like and then spray it with silicone spray. The wax will come right off.

Re: "Wax resistant" finish?

#6

Can't say I've ever seen a silicone recommendation

Dick Coers

Silicone sprayed on a piece of furniture will render it nearly impossible to refinish. A tiny bit of silicone will cause any new finish to fish eye. Purposely coating it with silicone spray.......... well I just can't imagine it!

Re: "Wax resistant" finish?

#7

Re: Can't say I've ever seen a silicone recommenda

Robin Corell in Atascader,ca

Silicone is commonly used as a mold release when pouring wax in rubber molds. I probably wouldn't spray it on a table which is l likely to need to be refinished at some point, but I see nothing wrong with applying it to a candle holder in an effort to keep from damaging the finish when scraping off melted wax.

Re: "Wax resistant" finish?

#8

Ellis Walentine

Lotta good suggestions here

Ellis Walentine

I'm going to try the silicone trick, on poly. I'd recommend making a wooden scraper, too, with a sharp edge to pop the wax off. Make it fancy so it complements the furnishings.

Ellis

Re: "Wax resistant" finish?

#9

JL

Re: Lotta good suggestions here

JL

Works for me.

I was planning on urethane. I will top coat w/ silicone or Teflon spray.