Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Tersa head issue

Posts

Tersa head issue

#1

Ellis Walentine

Tersa head issue

Ellis Walentine

I'm not usually on the asking end of questions around here, but I'm stumped by this one. I have a 10" jointer/planer with a three-knife Tersa head. I just flipped the knives over to the unused edges and fired up the motor to reset the little gibs. They're supposed to be re-wedged against the knives by centrifugal force, but for some reason they are still hanging loose. I can't figure out if it is just a matter of gunk in the slots preventing them from resetting, or if there's something I'm missing.

Any Tersa experts here?

Ellis

Re: Tersa head issue

#2

Ellis Walentine

Update

Ellis Walentine

Well, I got the cutterhead back in order. What I did was to take the knives out, spray some silicone spray on a piece of 600-grit carbide paper and dress the slots with the paper. I think what happens is that you get a little bit of oxidation (call it rust?) on the inside surfaces of this system and it is just enough to prevent the gibs from being thrown into position.

All's well that ends well.

Ellis

Re: Tersa head issue

#3

Re: Update

Bill Howatt

Glad you got it fixed.

When I got my first job in a research lab there was a lot of high-tech equipment for analysis, ultra high-vacuum work, etc. Naturally some of it used to fail and some people spent a lot of time digging through electronic circuit boards and calibration routines for the solution. There was an old tech (he seemed real old to me at the time) who would then step in when it was still not working and give everything a proper cleaning. He had a tremendous success rate for getting equipment working again.

Bill