Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Question on air pressure for spray gun.

Posts

Question on air pressure for spray gun.

#1

Question on air pressure for spray gun.

Barry Irby

I bought a spray gun as recommended by Bill Tindall. A Devilbis with a 30 Nozzle. Yesterday I tried to spray some small disks about the size of a silver dollar. It just blew them all over the place. I usually spray at 30 PSI. These disks would have been easy with a rattle can. I bought the gun used and got no manual or information. What pressure should I use? (This may explain why I used so much finish on a recent bed project.)

Re: Question on air pressure for spray gun.

#2

Practice!

Mark Mandell - Gone Round In New Jersey

30 psi should be OK; never used more than 50 with a conventional gun. The amount of finish used is determined, not by the air pressure, but rather where you have the material stop set.

Suggestion:

Fill your gun with water. Set your pressure at 30. Close the material stop, then open it 1.5 turns. Open your fan knob all the way. With the gun 6-8" above, spray a pass over a piece of copy paper. Look at the spray pattern for evenness. Try different settings for pressure, fan, and the material knob (and more paper) to find what gives the best atomization and even coverage. You can add a bit of dye to the water to help you see it, and can also use a heaver liquid like milk or cream to simulate the viscosity of the finish you will use.

Re: Question on air pressure for spray gun.

#3

Re: Question on air pressure for spray gun.

Ralph Lipeles

When spraying pieces that are very amall and light in weight, try securing them in place with 2 sided tape

Re: Question on air pressure for spray gun.

#4

PS

Mark Mandell - Gone Round In New Jersey

Gun-work is different from rattle cans. You should try to position your gun at 90° to the surface so that you pray down onto the piece(s); spray cans don't work well that way and need to be held at an angle like 45° to the surface. That should help with your moving pieces.

Re: Question on air pressure for spray gun.

#5

Re: Question on air pressure for spray gun. *LINK*

harmonpa

Your best route would be to tape down the products if possible. You can do an atomization check when your dialing in your spray gun essentially you only increase air pressure while spraying a sample piece of product until you get the desired break up. If its much above 30 PSI and its an HVLP SPray Gun you may consider adding thinner. You can get a general idea of finish quality based on various pressure settings from these guys article on using a pressure pot spray gun


How to Use a Pressure Pot Spray Gun