Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Any solid-surface experts around here?

Posts

Any solid-surface experts around here?

#1

A.J. Hamler

Any solid-surface experts around here?

A.J. Hamler

Hi guys...

After more than 12 years of living in this house, I need to give the solid-surface countertops in our bathrooms a little TLC. The thing of it is, is that I don't really know how. There are two main things I want to accomplish.

First, I want to simply remove the extremely minor everyday abrasion it's acquired over the years, and bring it back to as close as the original shine as I can. As noted, this is very minor stuff here, just a general dullness mostly. Would auto rubbing compound do it, or would that be too much (or maybe not enough)?

Second, I have some minor scratching my wife caused with emery boards. She rests her fingertips on the counter while going to town with the emery board on her nails, which inevitably hits the countertop repeatedly. There's all these little V-shaped scratch patterns -- left side of fingernail, then right side -- all over the counter in the bathroom she uses most. These are not bad or even particularly deep scratches, but at the right angle when they catch the light you can see those V marks and I want them gone. What's the best way to deal with those -- same as above? Something more abrasive?

Thanks in advance.

A.J.

Re: Any solid-surface experts around here?

#2

Not An Expert, But

Mark Mandell - Gone Round In New Jersey

Have repolished a Corian counter for a friend. Went to auto compounds (Mequire's). Used 3 grades on different cotton buffs, #2 fine cut, #7 Glaze and finish with # 9 Swirl Remover. They were pleased.

If, however, you've got deep scratches, I think you're going to have to get out the RO and, like any table top, work through the grit from 150 up through 800-1000 before you can start repolishing. I could, however, be wrong on this part ;)

Re: Any solid-surface experts around here?

#3

Re: Any solid-surface experts around here?

John K Jordan

>>>She rests her fingertips on the counter while going to town with the emery board on her nails, which inevitably hits the countertop repeatedly. There's all these little V-shaped scratch patterns

Yikes, sounds like the opportunity to make for her a nice little wooden fingertip manicuring rest from a fancy piece of exotic wood!

JKJ

Re: Any solid-surface experts around here?

#5

That's Mirka Abralon

Dick Coers

Works like a dream. Sanding solid surface is like sanding a gloss finish. Start course enough to cut out the problems, then keep using finer grits till you get the sheen you want. To do a really pro job, you'll need to pull the faucets and drain if the sink is integral.

Re: Any solid-surface experts around here?

#6

Re: Any solid-surface experts around here?

garthinsandiego

Check out the John Bridge tile and stone forum (http://www.johnbridge.com/vbulletin/index.php) Very helpful and a lot of good information.

Re: Any solid-surface experts around here?

#7

thanks guys!