Re: A different perspective
Derek Cohen (in Perth, Australia)
Derek is usually right, and I respect his opinions and often use his advice when I purchase tools
Of course. 
, but this time he is wrong*.
What! No!
Your jointer only needs to be a smidgen wider than half the width of your planer.
William, this needs explanation. Are you planning on reversing the board to plane the other half? What do you do with the guard?
But I wouldn't trade "up" to any 12" jointer with a wedge bed, because I wouldn't be sure of being able to tune it to my standards, or much less keep it tuned.
More explanation needed. Different construction types? Advantages and disadvantages?
I also am no fan of combo machines. The more moving parts and the more often you have to move them, the more you are going to put it out of spec and the more time you will spend tuning it up.
I can only speak for the Hammer. It has not lost a setting in the three years I have had it. This particular machine is built like a tank. I am sure that Hank would say the same. It is interesting that so few, if any, of these machines come onto the second-hand market (in Oz, at least). Either they are too poorly made or they are too well made.
That is an especially important issue when you are processing lots of boards for a large project. Switching between jointer and planer mode as you work the boards takes a lot of time and puts even more wear on the adjustable components of the combo machine.
William, the wear issue is hypothetical, however some indeed do not like switching between setups, and prefer separate machines. I would have separate machines if I had the space. If I were a pro, I would absolutely want the extra efficiency that comes from separates. I accept the limitations of a combo because, again I can only speak for the Hammer, the change over is quick. What one learns to do is plan work and become efficient that way.
I really value the 12" jointer. As mentioned earlier, it makes it possible to process wide boards. This aspect just cannot be stated frequently enough. In the case of the Hammer, the Euro Guard (in contrast to the Lamb Chop type) promotes a safer work process.
The carbide bits on the spiral head are outstanding for their longevity. The head may be doing double duty but the carbide outlasts the HSS blades by an order of 10 times or more.
The reason I have come back to reply to your post is that I find this machine, with the wide jointer, is as much of a game changer - for the amateur like myself - as the CBN wheel has been for sharpening among flat woodworkers (and you should see how that is taking off now!).
Regards from Perth
Derek