Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Angle drill guide?

Posts

Angle drill guide?

#1

JL

Angle drill guide?

JL

I typically drill angles in seats freehand. I mark out a seat with sight lines and use a couple of bevel gauges to "mark" the angle.

If you place a bevel gauge set to the angle on the "front" and "back" of where you want to drill - you can usually hit the mark.

As I taper my holes with a tapered reamer, I can "correct" any slight deviations from what I typically do.

I do have a couple of jigs for my drill press also.

However, I realize that for certain applications, it would be nice to have a drill guide. Anyone have any recommendations or favorites?

Re: Angle drill guide?

#2

Re: Angle drill guide?

John McGaw

On the very few occasions when I've needed to accurately and repeatably drill angled holes with a hand drill I've resorted to a throw-away block with a through hole pre-drilled at the proper angle and used it to guide further holes. Easy and cheap and, if it is made properly, it can be quite accurate. Obviously not adjustable so it might not work for you.

Re: Angle drill guide?

#3

Jack Guzman from Maine

Re: Angle drill guide?

Jack Guzman from Maine

I have used a predrilled block like John mentions. When I started building chairs I used your method. I found out that my "eye" is way off. My results were too unpredictable. I learned from Curtis Buchanan to use mirrors. I set up a mirror and hold my drill in line with the bevel as I drill.I use another mirror in the other direction at the same time with another bevel or square. I get exact angles every time.---Jack

Re: Angle drill guide?

#4

Smoke But No Mirrors

Mark Mandell - Gone Round In New Jersey

I've had a "portable" drill press attachment for a hand drill for years. It's worked quite well for 90 degree holes and tolerable for single slants; NFG for compound angles. On the rare occasions I need to drill those, I drill a matching hole through a 2" square block then lock it into my compound miter saw and slice one end with the compound angle. The cut end goes on the surface and then serves as the drill guide.