Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

T & G paneling question

Posts

T & G paneling question

#1

T & G paneling question

Bruce, a MN Galoot

I'm planning on making 1/2" tongue and groove cedar paneling for the back of a gun cabinet (client's request). The width is 29". Do I need to leave a little gap between each of the strips (about 4" wide) for expansion, or can they be run against each other?

Re: T & G paneling question

#2

Ellis Walentine

Calculating expansion...

Ellis Walentine

...depends on the moisture content of the wood, now and in its final home. If the MC is higher now than it will be during the most humid season, you don't need to worry about expansion. But, if the MC is at 8% now and is expected to rise to 12% in the summer, which is a pretty typical expansion scenario, at least for planning purposes, you will see about 3/16" overall expansion in 29", based on the known expansion coefficient for Eastern red cedar (aromatic cedar). In that case, I'd leave about 1/32" of room between your slats. If it is some other species of cedar, it will expand slightly more, because Eastern red is the most stable of the "cedar" species.

Ellis

Re: T & G paneling question

#3

Re: Calculating expansion...

Bruce, a MN Galoot

It's air dried and has been stored in a barn for five years or so. As I've planed it down, it hasn't cupped or twisted, though it's riddled with knots. This cabinet will be indoors, albeit Minnesota with its wide humidity swings, but likely air conditioned in the summer, very dry in the winter.

Thanks for the info. 1/32" spacing it is.

Re: T & G paneling question

#4

Re: Calculating expansion...

Keith Newton

If it is air-dried, it will likely be 12% ~ mc, and will go down to 6% indoors, so can probably go in tight.

Re: T & G paneling question

#5

Minnesota winters....

Brian Roberts

without proper humidification will take moisture content well below 6%.

The resulting "compression shrinkage" when summer humidity level expands wood to it's maximum is what destroys nicely fitted joints.

That is also why good quality furniture (and violins) are designed to be taken apart and reglued periodically.

Designing to eliminate cross grain joints and use of hot hide glue are prudent practices also.

Re: T & G paneling question

#6

Ellis Walentine

Re: Calculating expansion...

Ellis Walentine

It won't hurt to allow a little gap, but, as Keith (and I) said, if it's at a higher MC now than it will ever get, you can live without the gap. Air dry wood stored outdoors is probably around 12% or more, and MC in the humid season up there is probably about the same, so it's a coin toss.

Ellis