Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

plugs for covering fasteners

Posts

plugs for covering fasteners

#1

plugs for covering fasteners

Bill P.

I have a matched set of bits from Lee Valley for drilling and making plugs to cover the holes. The bit for making the plug is tapered so to fit perfectly in the counterbore. My question is, at what depth should the plug enter into the hole. My first test plug only went in about 1/8" using just enough pressure so I could get it back out to measure it. I'm sure with a gentle tap I could get a total of 3/16" with out stressing the part, is that enough. I'm making a pair of porch swings out of white oak for Christmas gifts. They won't see direct rain or snow but some sun.

Thanks, Bill

Re: plugs for covering fasteners

#2

Re: plugs for covering fasteners

Barry Irby

I have a set of ones that did not come from Lee Valley. The most common use I have made of them is repairing screw holes in door jambs. If a hinge screw is wollowed out I drill a 3/8 hole into the ruined hole and then drive in a plug of similar pine and reinstall the screw. In flipping houses I have done about a hundred of them. I drive them in about a half inch generally with a little Titebond.

I use a scrap of pine and drill about twenty five of the plugs. Then I put a piece of tape over them and use the bandsaw to "resaw" then off all at one time. You can pop them out of the holes with a small screw driver, but they tend to be ragged that way.

You can also carefully pick the grain and the plugs will match nicely.

Re: plugs for covering fasteners

#3

Jesper, Denmark

Re: plugs for covering fasteners

Jesper, Denmark

1/8" is plenty - and do not tap in too hard, so that the bung gets compressed, or it will stand proud when exposed to the weather.