Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

fixing Delta/Rockwell planer

Posts

fixing Delta/Rockwell planer

#1

fixing Delta/Rockwell planer

john lucas

I went to a friends shop today to fix his planer. It is a Delta/Rockwell 13" built in 1970. It wasn't feeding boards. I removed the blades last week so we could get them sharpened. He cleaned and waxed the bed and cleaned all the feed rollers. I put it back together today with the new blades and it still wasn't feeding properly. The board just stops. We adjusted both the infeed and outfeed rollers. It seems like it might be binding up on what they call a chip breaker. I just watched a video by Bob Vaughan and he calls the one on the outfeed side a pressure bar. .In the manual it says this doesn't need adjusting however that are adjustment screws. It's hard to see how that thing works. We tried adjusting it up and down and we still have the same problem. Anyone have this planer or know how to adjust the pressure bar or chip deflector. Also there weren't any specs on the blade height. He didn't have the little tool that probably came with the planer. I used my mini magnetic planer blade alignment tool to get close and then adjusted the blades with my dial indicator to within .003 of each other and end to end.

Re: fixing Delta/Rockwell planer

#2

Re: fixing Delta/Rockwell planer

walta

There is a poorly designed brass gear in that planer often fails.

I am not sure what the symptoms a total gear failure produces.

From time to time someone on OWWM.com will have a few custom made in the $300.00 ball park.

Walta

Re: fixing Delta/Rockwell planer

#3

Re: fixing Delta/Rockwell planer

Bill Tindall, E.Tn.

I owned this machine. Sent thousands of bdft of lumber through it before we got a larger machine. The symptoms are consistent with the pressure bar being too low. It should be just slightly taller than the finished thickness of the planed board. That is to say, it should be a few thousandths above the cutting circle. I would just adjust it empirically. Raise it till the lumber feeds well. If it is too high you will get snipe.

I presume you have checked and seen that the feed roller is rolling and not exerting excessive pressure.

Re: fixing Delta/Rockwell planer

#4

Re: fixing Delta/Rockwell planer

john lucas

Bill After watching Robert Vaughan's video I believe you are right. I can probably rig up a dial indicator to read it. We set the infeed and outfeed roller using a jury rigged piece of wood like they show in the manual but if I rig up my dial indicator and can set those more accurately and set the pressure bar .003" higher which is what he recommends.

Re: fixing Delta/Rockwell planer

#5

what I did

Bill Tindall, E.Tn.

In the beginning I took the engineering approach and set it to+/- 0.0000etc of some standard. Over time I just set it close and if the lumber didn't feed I raised it part of a bolt turn until it fed ok. The only down side of the bar being too high is snipe. If you aren't getting snipe it is not too hign.