Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Exterior Door with Sun & Heat Exposure

Posts

Exterior Door with Sun & Heat Exposure

#1

Exterior Door with Sun & Heat Exposure

Donna Burch

Does anyone have a suggestion for an exterior front door finish that gets a lot of sun and heat exposure during the summer? I believe the wood is oak, so I'd also like to apply a light stain. Everyone I talk with seems to have a different answer (spar varnish, wipe on oil/varnish, general finishes exterior 450,..).

Thanks, Donna

Re: Exterior Door with Sun & Heat Exposure

#2

Re: Exterior Door with Sun & Heat Exposure

Dick Coers

Any stain and clear coat is going to take a lot of maintenance. Often yearly. A storm door with lots of glass makes it even worse. The storm door makes it a mini green house with even higher heat and expansion. I love wood, but have a steel front door.

Re: Exterior Door with Sun & Heat Exposure

#3

Tough one...

John in NM

The problem is that the sun breaks down all finishes, so you are left with maintenance choices to make. Finishes like spar varnish should last longest, but they are the most tiresome to refinish - the door basically must be fully scraped or sanded down to the wood and recoated. You might get away with recoating before there is even a hint of peeling, but I've never tried that.

Oil finishes break down much faster, but you can simply recoat them when they start looking thirsty. They do not make for a glossy finish however, and not everyone goes for a non-film look. In my area (7000' elevation, lots of sun) you would have to recoat at least 3-4 times the first year, then maybe twice a year after that.

The other option to consider is a high quality paint outside and a nice varnish inside. Enjoy the grain inside and enjoy the superior weather proofing of paint outside.

Re: Exterior Door with Sun & Heat Exposure

#4

Re: Tough one...

Larry Copas

Quality paint or a roof are the only two options for low maintenance. Don't listen to the snake oil sales pitches.

Re: Exterior Door with Sun & Heat Exposure

#5

I have experience

Bill Tindall, E.Tn.

You need a Marine varnish which is not the "Spar Varnish" to be found at Lowes. You can get these finishes from Jamestown Distributors or if you live near the sea any place that does boats. Not cheap, by the way.

The finish will be dark, but it will last in the sun and rain.

Re: Exterior Door with Sun & Heat Exposure

#6

Re: Exterior Door with Sun & Heat Exposure

Mark Nowicki

Finishes intended for marine use would be my choice.

The mahogany centerboard on my sailboat is finished with Interlux BrightSide paint

http://www.westmarine.com/buy/interlux--brightside-one-part-polyurethane-paint--P004_121_002_006

My rudder (marine plywood) is finished with West System 105 Epoxy resin.

http://www.westsystem.com/ss/

Re: Exterior Door with Sun & Heat Exposure

#7

Epifanes, along with...

Grant Smith

Hi Donna,

Many have tried to maintain a wooden door on a sun facing wall of their homes. Most have failed. Here are strategies to give it the best chance:

1. have an architect draw an overhang retrofit solution to keep the door out of the sun. This is the best long term approach. I say architect, because they are most qualified to both consider aesthetics as well as function.

2. Know that whatever the solution, you will need to periodically re-coat the door, perhaps annually, and certainly at least every two years or so to keep a film finish in place. I have a white oak door, sidelights, and transom that I have managed to keep up with 9 years now. It is the focal point of the front of our home, has about a 4' overhang, but still sees afternoon sun and Iowa winters, thunderstorms, etc. I purchased a "backup door", that I put in place when I did a major refinish. This is much easier work on sawhorses rather than with the door hanging.

3. Research finishes, focus mostly on marine finishes, as they are designed with sun and weather in mind. If you want expert advice, first read their website, then call Jamestown Distributors for the final advice before you make a purchase.

4. I did the above, then landed on Epifanes clear wood varnish. Much of my decision was based on a review of outdoor finishes with that product coming out on top. I wanted a clear finish, but your project will be more sun resistant with solids in it, so do your own research.

5. Know that patience and workmanship is key to a finish that will hold up. You cant expect to slop on two coats of something from the local chain store and expect a long lasting exterior finish. The product I suggested above works best with upwards of five coats, each thinned in decreasing amounts, starting with bare wood. It can be top coated without sanding between coats if you do the next coat at the right time.

6. Methods of work: I shook and stirred the product, decanted an amount needed in to a quart resealable jar, added thinner as recommended on the label. Applied coat #1. Next day, within the label recommendations, I did some mental math to determine the next amount of thinner while not wasting the remainder of the previous days varnish, added the appropriate amount of thinner and finish to the same jar, then re-coated. I proceeded like this for each of six coats. The first five coats were applied with a high quality foam brush (also available at Jamestown Distributors). The sixth coat was applied with a high quality brush designed for varnish.

7. You must have a passion for a great looking natural wood door. If you approach it like a labor of love, you can get great results. If you think it is a one day project, you will not likely like the results long term.

8. Re-coating will be necessary periodically. Usually more so on the lower portion of the door where driving rain and the most sun will hit the door. Read the can for recommendations.

http://www.jamestowndistributors.com/userportal/search.do?freeText=epifanes+clear+varnish&page=GRID&engine=adwords&keyword=epifanes_clear_varnish&gclid=CJeVxon35s8CFQgOaQodsTQOmQ

No affiliation with Jamestown Distributors, just a very happy customer. For a door, or even one with sidelights, you will not need more than a quart. Resist the urge to order two because the shipping rate is cheaper.

FWIW,

Grant in Iowa

Re: Exterior Door with Sun & Heat Exposure

#8

Ellis Walentine

Thanks for the thorough response!


Re: Exterior Door with Sun & Heat Exposure

#9

Re: Epifanes, along with...

Donna Burch

Thanks to everyone for their great responses!!! A couple of people recommended Jamestown Distributors, so I called them and they recommended Epifanes. After I finish sanding/prepping the door, I'm going to very lightly stain and then apply their Woodfinish since the doors are oak. If after a few years I get tired of the upkeep, I'll go back to paint. But I love the look of the doors for now. After I'm finished, I'll post a picture.

Thanks again,

Donna