Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Weatherproofing a wooden cross

Posts

Weatherproofing a wooden cross

#1

Weatherproofing a wooden cross

Bill P.


My parents had a wooden cross made for their front yard a couple years ago. They had someone refinish it but it didn't hold up very well. I'm not sure what they used to finish it though. I suggested a marine sealant, what are your thoughts or suggestions. It's made of Mahogany and weighs about 600 pounds.

Thanks, Bill

Re: Weatherproofing a wooden cross

#2

Ellis Walentine

Re: Weatherproofing a wooden cross

Ellis Walentine

I know of no clear finish that will last more than one to two years outdoors without recoating every year. I've had good luck with spar varnish.

Ellis Walentine, host

Re: Weatherproofing a wooden cross

#3

Re: Weatherproofing a wooden cross

Chuck in Mtl.

Mahogany does withstand the effects of weather very well without any finish. I think it will become grey with time. What about using some type of oil finish like tung oil? It will need to be applied every year I am sure.

Re: Weatherproofing a wooden cross

#4

Re: Weatherproofing a wooden cross

John K Jordan

I've had good results with boiled linseed oil when applied to bare wood. I've been using it on tool handles at the farm after some advice here years ago.

I have three barn doors that show no signs of weathering after 6 years now. I applied the BLO to rough cut lumber, if that matters. Perhaps it soaked in better that way. It does make the wood darker.

JKJ

Re: Weatherproofing a wooden cross

#5

Re: Weatherproofing a wooden cross

TomD

It would be possible to make something that looked like that relatively durable if epoxy was used, but it would never work with such heavy sections. One would need to go to some crazy extreme like building a form out of plywood, coating that all over in epoxy, even glassing parts of it, then veneering the surface say 1/2" thinck, sealing everything, maybe with glass, and then using a catalyzed varnish. Obviously not applicable in this case.

On Mahogany, Deck Olje might work, or Watco marine oil. Where they can be superior to varnish is they are not merely on the surface. I have some experience with Watco marine, but not as severe a situation as what you have going on there. Decks has been the rear cover of Wooden boat, or was, for decades.

http://www.jamestowndistributors.com/userportal/show_product.do?pid=168

http://forum.woodenboat.com/archive/index.php/t-124387.html

If I went with Decks, I would make a hat out of copper or vinyl something for the top, make it inconspicuous, but something to protect the end grain (even white latex paint). And I would soak marine epoxy into the endgrain of the arms. I would not put epoxy anywhere else (well maybe knots if there are any).