Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

replace prehung door

Posts

replace prehung door

#1

replace prehung door

JB

I am replacing an existing door and jamb. I want to replace with prehung. The door will need to be fitted to the inside flooring material (carpet), because it swings in. The existing door is 79", so it's been cut to accommodate carpet. When I removed the existing jamb, I see that it goes a SOLID inch below the existing finished tile on the outside of the door. The surface below seems to be either a glue or rubber material. What do you suggest? Should I fill in the gap with something? If so what? I was thinking of concrete, but I'm not sure if it will work because of the glue or rubber below? Should I purchase the prehung and extend the jamb at the bottom? If so, how?

The door manufacturer states that the door can't be undercut more than 1" max. It's a solid core door.

Re: replace prehung door

#2

Re: replace prehung door

Paul Leuba

Would it work to cut the bottom inch from the old jam and use it with some construction adhesive to fill the gap from whence it came?

Re: replace prehung door

#3

Re: replace prehung door

Bill Howatt

Is this problem because you don't like the jamb sitting above the floor or is it cosmetic on the tile side because there will be a "hole" around it?

The jamb does not have to sit on the floor to be secure. It is well attached to the framing by the time it is nailed and the casing added. The weight of the door is suspended from the hinge side and you can replace one of the screws in each hinge with a long one that anchors it well to the framing.

If it makes you feel better, and it probably isn't a bad idea anyway, you can fill the gap with a piece of the old one as suggested.

Bill

Re: replace prehung door

#4

Re: replace prehung door

Ralph Lipeles

Can't you just use a jam with whatever thickness shim is needed under the jam?