Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

WC Weekend Accomplishments....

Posts

WC Weekend Accomplishments....

#1

WC Weekend Accomplishments....

Dennis E Peacock

12 Sep 2016

Good Morning Everyone,

Just getting an early start to what I'll call...a busy week. As you may recall, I agreed to some projects to help our local bowling alley do some renovations and improvements. We agreed to break it all up into 4 different phases. Phase 1 was a new shoe storage rack for the customer service desk to free up some much needed floor space. Done, delivered, and collected the money. Phase 2 which was making and installing a 10' counter top plus three 24" wide three drawer cabinets and one 18" three drawer cabinet. Stained, finished, lacquered, formica on the hand-built counter top, to include a formica end-cap to put a permanent end to the cabinets and counter top space. Done, delivered, and collected the money. Phase 3 will be 3 shoe storage units to hold about 200 pairs of shoes, a counter top that is 36" wide and 10' long, and a swinging door to exit and enter the new work space. This is what I will be starting very soon. I'm enjoying the work and the shop time but like I always do, I under-bid the work. :)

Getting stuff done around the house, fixing a busted lawn mower, and refinishing a chair for a good buddy of mine so the LOML can re-upholster it for me.

That's it for me, so what did you do this past weekend?

Best of weeks to you all.

Dennis Peacock

Re: WC Weekend Accomplishments....

#2

Re: WC Weekend Accomplishments....

CharlieL

Speaking of working on a lawn mower, I replaced the pull cord on ours yesterday and found out that 3/16" braided nylon cord is too big. It's so thick that I can't get enough cord onto the pulley to get a full pull. So today I'll be taking it back apart and replacing it with what I should have, 1/8" starter cord that the local hardware store has in a bulk roll at .24 cents a foot. It should go a lot quicker today now that I know the steps to do it. Which involve removing the gas tank, oil fill tube, grass chute, and top cover. Kind of a pain in the backside if you ask me. It would be a lot simpler if the rewind assembly was not riveted to the top cover, and instead was just bolted to the top cover so I wouldn't have to remove everything else to get the job done. Makes me wish for the simple old style detached cord pull that you wrap around the cup shaped with cord notch part. But it is what it is, and another lesson learned.

Re: WC Weekend Accomplishments....

#3

Re: WC Weekend Accomplishments....

AZ in Colorado Springs

Sharpened five plane irons ...

Recently someone opined in a post that he ought to take a day for a sharpening binge. I was planing some poplar and it seemed like time to sharpen, so I took that man's advice and sharpened several planes.