Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

SDS Drill question, Dying?

Posts

SDS Drill question, Dying?

#1

SDS Drill question, Dying?

Barry Irby

I have a Bosch SDS drill and used it heavily the other day. It got hot. It leaked oil out the business end and over/through the chuck. Likely some seal has failed, Right? Any suggestions?

Re: SDS Drill question, Dying?

#2

Maybe not a seal

Dick Coers

I don't know the exact workings of that drill, but they often use a heavy grease on the cams. You may have just overheated it and melted the grease. At the very least you'll need to get inside and apply the correct new coat of grease.

Re: SDS Drill question, Dying?

#3

Re: SDS Drill question, Dying?

John in NM

I don't think it's dying. Mine did that years ago and it still works.

Re-greasing isn't a bad idea, but beware of fiddly mechanisms inside :D

Re: SDS Drill question, Dying?

#4

Re: SDS Drill question, Dying?

John K Jordan

Mine did that, still works fine. I think the rotary dial to switch between hammer/hammer drill/drill was also a port to add more oil but it's been decades and I can't remember.

JKJ

Re: SDS Drill question, Dying?

#5

Re: SDS Drill question, Dying?

John McGaw

Have to agree with the others -- it is probably OK. I have the Bosch 'Bulldog' (can't remember the number and I'm too lazy to go look) and it has occasionally shed a bit of oil/grease over 10+ years of use with no detectable downside.

Re: SDS Drill question, Dying?

#6

Re: SDS Drill question, Dying?

Joseph Mulherin

Barry, go and buy the Rockwell hammer drill....cost about $136. It also is a regular drill for screws.

Re: SDS Drill question, Dying?

#7

I used it a few minutes today and....

Barry Irby

It seems fine. Wiped it down to keep the grease off my hands and stuff. Hope it holds up, it does not have a lot of time on it.

Re: SDS Drill question, Dying?

#8

Re: SDS Drill question, Dying?

Jerry Nicholson

My Craftsman half inch drill has seeped a little grease ever since I got it - about 55 years ago. Still works fine!

Jerry

Re: SDS Drill question, Dying?

#9

Jason Roehl in Lafayette, IN

Re-paint with grease and thin no more!

Jason Roehl in Lafayette, IN

I have a 20-year-old Milwaukee hammer drill that did that to me about 10 years ago. I took apart the gearbox, cleaned it up and put in new grease. Good to go.

Jason