Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Need to cut a weird angle on table saw

Posts

Need to cut a weird angle on table saw

#1

Need to cut a weird angle on table saw

Ron Peterson

Hello, I am making a table that has an angle coming down from the top that I need to make a table leg going down at 90 degrees. I have calculated the angle that I need to cut on the leg piece and it is 40.7 degrees. My Unisaw will only go down to 45 degrees. I am thinking that it I put my saw at 45 degrees and lift the board through on a cross cut sled at 4.3 degrees that I can achieve this angle. Is my thinking correct?

Best regards,

Ron

Re: Need to cut a weird angle on table saw

#2

Kneale Brownson

Re: Need to cut a weird angle on table saw

Kneale Brownson

I'd fasten something to the board to ride on the table to achieve the desired angle.

Re: Need to cut a weird angle on table saw

#3

Need a Visual

Mark Mandell - Gone Round In New Jersey

Ron,

Can you do a drawing of the part showing the angle you need to cut? I'm just not "seeing" what you need to do from the word description.

Re: Need to cut a weird angle on table saw

#4

Re: Need a Visual

Barry Irby

I agree with Mark. If your saw will cut a 45* angle why won't it cut anything less? You don't have a stop or index for the lesser angle, but you can set the blade and lock it. Thus, I assume I am not understanding the question.

Re: Need to cut a weird angle on table saw

#5

Re: Need a Visual

John K Jordan

I wondered the same thing. I assumed it was a matter of how the angle was measured (the way a 30-deg angle is also a 60-deg angle depending on the reference plane.) If so, perhaps clamp the leg stock to a vertical jig or better, to an angled wedge and leave the saw blade vertical.

Re: Need to cut a weird angle on table saw

#6

Re: Need to cut a weird angle on table saw

AZ in Colorado Springs

Build a tall fence that rides on top of your table saw fence and clamp the work piece vertically to it. Set the blade for 4.3° bevel. Voila!

Re: Need to cut a weird angle on table saw

#7

what I'd do

Tom Sontag - St. Louis

I would draw the cut on all four sides of the leg piece, cut close to the line with a handsaw, and then clean up the cut with my low angle block plane.

I do not trust my machinery to get fractions of a degree accuracy and it does not sound like you are making dozens, so skip the elaborate jig approach and just have at it.

Re: Need to cut a weird angle on table saw

#8

agree

Bill Tindall, E.Tn.

Agree except I would cut the rough angle on the band saw because I have one.