Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Protective Finish

Posts

Protective Finish

#1

Protective Finish

Jill

I have an antique Chinese birdcage out of bamboo/wood. It is very old and the parts that are wood need something to protect them from splitting. The bottom of the cage on the outside is fading and I already have a crack on the side wood. About 15 years ago, I put a coat of Sam Maloof on it but that's long gone. It's thin wood, and the "bars" on the cage are bamboo and will part crack if not handled very carefully.

I am looking to apply another protective finish to help prevent further cracking or splitting. I would also do the bamboo bars on the upper portion of the cage. I need help getting the correct finishing substance that will give it protection. Shellac? Varnish? ???? Help! Thank you.

Re: Protective Finish

#2

The Original Chinese Finish

Mark Mandell - Gone Round In New Jersey

Would have been solvent lacquer or shellac, most likely shellac.

You're seeking a finish to protect the wood from splitting is going to fail. Splitting ("checking") is caused by drying, changes in moisture content, and the character of the wood itself. Shellac or lacquer will retard moisture exchange from the air and seasonal humidity variations, but nothing with completely prevent the wood, and bamboo, from expanding and contracting.

Spray a coat or two of shellac or lacquer (both are available in spray cans) and be done.

Re: Protective Finish

#3

spar varnish

Bill Tindall, E.Tn.

but paint would be more permanent

Re: Protective Finish

#4

Re: Protective Finish *LINK*

Yonak

Jill, I can't really envision the cracks and splits you are talking about but, if this is a valuable or keepsake piece you may want to get it professionally restored. If not and if the components are deteriorating, you may think about repairing split members with glue before finishing. I wouldn't imagine a finish would protect any bamboo from splitting.

If all the parts are brittle, short of impregnating them with some sort of preservative, such as some materials that are used to modify wood to make pen blanks and knife handles, etc., I would put the cage where it could be seen but not handled.

Otherwise, although I cannot personally vouch for it, you could investigate a product such as this :


Low viscosity penetrating epoxy