Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Hose Fitting Sought

Posts

Hose Fitting Sought

#1

Hose Fitting Sought

don stephan

Can anyone suggest the name of the fittings in the attached picture? One is a smooth shaft about 1/4" x 1 1/4" with a hose barb on the other end, the other grips the smooth shaft until the green plastic collar is pulled back.


Re: Hose Fitting Sought

#2

Re: Hose Fitting Sought *LINK*

John in NM

Those are called "push to connect" fittings.... at least that's what I've seen them called. We have those things all over the telescope, though I didn't know you could use them with a brass tube too. Ours just bite into the plastic hose.


http://www.mcmaster.com/#push-to-connect-tube-fittings/=13iygia

Re: Hose Fitting Sought

#3

Re: Hose Fitting Sought

AZ in Colorado Springs

Why do you need hoses all over a telescope?

Re: Hose Fitting Sought

#4

they used the hose to blow the dust off the lens..

Barry Irby

And found out Pluto was a dust speck.

Cleanliness is next to impossible.

Re: Hose Fitting Sought

#5

Re: Hose Fitting Sought

John in NM

The primary mirror weighs over a ton and "floats" on a bunch of air piston/diaphragm things. This allows the mirror to be moved around for focus & scale changes using very small motor actuators - large actuators would stress the mirror and cause optical aberrations.

Then there are also a series of small air pistons that push on selected points in an attempt to correct the mirror's minor astigmatism, and then there are various shutters and latches that are air actuated.

Re: Hose Fitting Sought

#6

Close...

John in NM

We use CO2 "snow" to blow dust and pollen off the optics. Its made with a high pressure cylinder of CO2 that has a dip tube so what is expelled from the cylinder is liquid rather than gas. The lower pressure causes it to freeze into a fluffy powder of dry ice that knocks dust off the optics without scratching the aluminum coating.

We also make ice cream using liquid nitrogen and a paint mixer now and then :D

Re: Hose Fitting Sought

#7

Re: Hose Fitting Sought

Lee Schierer in McKean, PA

They are called push to connect fittings and mad by companies such as Legris and SMC. They can be used for water or air. Be aware that they come in metric and fractional sizes.

Lee