Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Winding sandpaper on drumsander question

Posts

Winding sandpaper on drumsander question

#1

Winding sandpaper on drumsander question

Barry Irby

I have some sand paper that is not the standard 3" wide strip for the Perfomax.

Some of it is about 2" wide. Has any body tried winding a different width strip? Does it work? What happens if there is a space between the windings?

How about wider paper/cloth?

Re: Winding sandpaper on drumsander question

#2

Re: Winding sandpaper on drumsander question

Stuart Johnson

I have a WoodMaster and haven't tried it but I think (dangerous) if the end was cut at the correct angle it would wrap okay. I don't know how that angle is determined. You might cut some strips of paper and play around in the middle of the drum until it wraps without overlapping or with gaps. Hold that in place and draw a line around. When you unroll it the line will give you the angle.

Re: Winding sandpaper on drumsander question

#3

Re: Winding sandpaper on drumsander question

john lucas

I would wrap it loosely around the drum from end to end. The go back and take some masking tape and do a wrap around the middle. Now wrap the sanpaper around the drum in each direction until you get to the end. Cut the end off at the angle that matches the end of the drum. Do the same in the other direction. Then pull the tape off of the middle and you should be good to go.

To answer your question about leaving a gap. I don't think it would hurt but would probably reduce the efficiency quite a bit.

Re: Winding sandpaper on drumsander question

#4

Re: Winding sandpaper on drumsander question

John K Jordan

My 22-44 came with some gaps near one end of the drum. I couldn't tell any difference in performance.

JKJ