Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

A $60 drawer pull, holy cow! *LINK*

Posts

Re: A $60 drawer pull, holy cow! *LINK*

#2

Sure looks like...

John in NM

A slice of some rectangular tubing, doesn't it? :D

One outfit I used to work for charged worse than that for handmade drawer pulls. Making some of those is how I learned that a wire wheel on a bench grinder is a very dangerous thing!

Re: A $60 drawer pull, holy cow! *LINK*

#3

Don't Ask

Mark Mandell - Gone Round In New Jersey

about the price of the dresser ;)

Re: A $60 drawer pull, holy cow! *LINK*

#4

Re: A $60 drawer pull, holy cow!

Barry Irby

Thanks for posting, I bought 8.....NOT!

Years ago I made a chest of drawers and the pulls were so spendy I made my own.

Re: A $60 drawer pull, holy cow! *LINK*

#5

Re: Reminds me of this guy.

Mark Nowicki


Re: A $60 drawer pull, holy cow! *LINK*

#6

Did you notice that it is Sold Out? 


Re: A $60 drawer pull, holy cow! *LINK*

#7

and Don't Ask

Mark Mandell - Gone Round In New Jersey

what to do when a pull splits out the back half of the drawer front or when the stretcherless brass table legs get bent.

Re: A $60 drawer pull, holy cow! *LINK*

#8

Pretty sure it's not being sold yet

Dick Coers

It was just shown to the public last week at a contemporary furniture show.

Re: A $60 drawer pull, holy cow! *LINK*

#9

From a visual design perspective I like it.

Chuck Nickerson

I realize we're only supposed to pile-on about the cost, but I like the way the visual of the pull continues as you pull the drawer out.

From a structural design perspective I'd be concerned about how weak it is. The pull cuts through the long grain of the door front.

I think I've got some testing to do.

Re: A $60 drawer pull, holy cow! *LINK*

#10

Re: From a visual design perspective I like it.

Mike Circo

As there are no visual fasteners holding it in place, and the questionable strength of what we see in that one picture, I wonder about something. Perhaps the inside face we cannot see is a long place say an inch or two long that is screwed to the inside face of the drawer. that would give it a wide surface to pull against.

Re: A $60 drawer pull, holy cow! *LINK*

#11

Re: A $60 drawer pull, holy cow!

John McGaw

The price is not what would scare me -- how difficult will it be to get a perfect fit on this hardware? It looks as though the cuts needed would be beastly difficult and even a fraction of a mm of error or chipout would ruin the whole piece. High-end hardware seems invariably high-priced from my (admittedly cheap) perspective. Ever used Brusso? Theirs is not custom but the prices can really get up there.

Re: A $60 drawer pull, holy cow! *LINK*

#12

That's one of the options I sketched out

Chuck Nickerson

last night over dinner. The inside plate then leaves room for some custom decorative work, or not. This idea may yet sprout wings.

Re: A $60 drawer pull, holy cow! *LINK*

#13

Re: A $60 drawer pull, holy cow!

Alexander Grigoriev

>how difficult will it be to get a perfect fit on this hardware?

CNC