Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Hand Tool Chat tonight 9:30 PM EDT

Posts

Hand Tool Chat tonight 9:30 PM EDT

#1

Hand Tool Chat tonight 9:30 PM EDT

Bob Entwisle in NJ

Ok, once again it’s Tuesday and 9:30-Pm EDT is time for the hand tool chat.

This week’s topic is vises (vices for some of us), What makes for a good bench vise?

The gold standard for many is a record 53 (ED?), no longer made by Record, but copied by several. I have an Anant clone of the 53 which is pretty serviceable though not quite as well refined as the Record, and I think there are one or two other Record “clones’ available out there. Then there is the LV twin screw, or how about an Emmert Pattern Maker's vise, or clone? For the past couple of years the Moxon vice has gotten more than a couple of column inches in most of the WW magazines. The Moxon, for many of us, solves the issue of “I can’t see that far without my other three pairs of glasses” since the Moxon mounts up on top of the bench and raises the height of the work to a manageable (now I can see it) level. Of course there are about a gazillian other work holding arrangements too. So what’s your go-to vise, or wish I had one, or other work holding method?

Anyway that’s what we’re going to start out with as a topic for the hand tool chat this evening, but as always we’re open to just about anything if it has even a remote relation to woodworking, so click on the chat room at 9:30PM EDT and join the fun.

Hope to see you there,

Bob in NJ