Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Texturing wood handles

Posts

Texturing wood handles

#1

Texturing wood handles

John in NM

I've made several tools to put a rough stippled texture on wood grips:


Just for fun I did the same to a few handles:


Close ups:



Kind of goes against the grain to intentionally tear up wood rather than sand it smooth :D -- but the results are nice and grippy.

Re: Texturing wood handles

#2

Re: Texturing wood handles

John McGaw

I still occasionally use the method John Jordan showed a class in hollow-forms. It is highly technical and involves cutting off a nail of the proper diameter, rounding the end, and chucking it in a reciprocating carving tool. If you have the tool it is essentially free, takes five minutes to do, and produces amazingly good results with a bit of practice.

Re: Texturing wood handles

#3

Re: Texturing wood handles

John in NM

That is similar to my latest iteration of this tool, except mine has multiple points so it goes a lot faster than a single point.

The first one was a bunch of cut nails sharpened and welded together on the end of a rod, making a hammer like tool. Probably worked the best of all I've tried, but it was slow and hard on the elbow.

There are a number of ways to drive the pointy bits, all depends on budget and desired longevity (the only durable reciprocating tools I know of are air driven stone carving tools and cost a fortune).

Re: Texturing wood handles

#4

Re: Texturing wood handles

Don Orr

Nice! I have also heard of people using a cheap welders air driven scaling tool with the ends rounded over. I think HF has a small one with thin rods.

Re: Texturing wood handles

#5

Leo Cuellar

Re: Texturing wood handles

Leo Cuellar

While I haven't used one of the HF scalers for texturing, I have put in several long sessions with one, removing rust from industrial shredders. They are a surprisingly tough little tool, I've had mine for 3 years now.