Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Door frieze proportions

Posts

Door frieze proportions

#1

Door frieze proportions

GolfSteve in Calgary

Hi Folks,

I’m stressing over something small. I’m replacing all of the trim and doors in my 1970’s bungalow with vertical grain fir. I have 8’ high walls.

Baseboards are 3-1/2” tall

Vertical casings are 2-5/8” wide

I’m making the door headers, and can’t decide how tall to make the frieze (the flat part below the top molding).

Which do you like best: 4.5” tall frieze, 4”, 3.75”, 3.5”, or 3” ?


Re: Door frieze proportions

#3

Re: Door frieze proportions

Dick Coers

Hard for me to say. I would consider adding a plinth at the bottom of the casing for a heavier feeling to it. I'd suggest you mock it up with cardboard. Since you will be looking slightly upward standing by the door, the dimensions will look differently than on paper.

Re: Door frieze proportions

#4

Questions

Mark Mandell - Gone Round In New Jersey

Crown moldings?

Wainscotting?

Any arch ways or room entry ways or windows that will be trimmed out as well?

What may work for a door may not work well over walk-thrus and over windows, and your trim style should be consistent.

Re: Door frieze proportions

#5

Re: Questions

GolfSteve in Calgary

No crown molding or wainscoting.

No archways or passages that will be trimmed.

The windows will receive a simpler treatment without the header molding.

Re: Door frieze proportions

#6

#3


Re: Door frieze proportions

#7

Ellis Walentine

Just another option...

Ellis Walentine

Our home was renovated about 120 years before yours was built, but the door casings are kinda timeless, and I like the proportions. Basically, all the casings -- sides and head -- are the same width (about 3" for doors with 3 3/4" stiles), and the ogee molding runs all around the door, right to the floor.

2¢

Ellis


Re: Door frieze proportions

#8

Full shop

GolfSteve in Calgary

Thanks everyone. I think I'm going to go with the 3.75" frieze. We'll see how the first door looks and then go from there.

Re-doing a house interior, plus two side tables waiting to be finished plus a bunch of guitar making jigs plus a large wood rack plus a number of stationary tools plus a big workbench equals not much room to work :-(