Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

cutting square

Posts

cutting square

#1

cutting square

mike mcnerney

You would think this is a no brainer but after a lifetime of work I can still find cutting square a trick sometimes. I only have a 10" table saw.

I am making a solid ( or I may change my mind & go hollow) 5.5" x 5.5" walnut leg that will mount to a 38" x 80" solid table top via a piece of steel.

I am going to set it back 1/8" from the edge of the table.

When I've done this kind of thing before on the TS I get some little 'steps'

Is there any way to get it perfect?

MM

Re: cutting square

#2

Re: cutting square

Barry Irby

If you have a 6" jointer and a planer you could saw two faces at 90 degrees as best you could and then joint them and plane the other two.

Without a jointer and planer, you could set the saw blade to lean out from the fence about a degree or two jj saw a face, leaving a very slight bulge in the center and then hand plane or sand the bulge away. Do one face at a time or at least two that are at 90 degrees.

Four of these legs? That's going to be some heavy table.

Re: cutting square

#3

Re: cutting square

John in NM

Mine does that too, and I usually cut oversize and take off the excess with the jointer or a hand plane.

On my saw the problem is caused by the fence leaning in a little I believe. I should fix that but never seem to get to it.

I have also seen similar problems with my sliding chop saw caused by dull carbide. The blade still cuts well - because its carbide, but there can be enough cutting resistance to cause the blade plate to deflect. This was trimming ends, might not do it in a full cross cut. Something to think about though.

Re: cutting square

#4

What other machines do you have?

Dick Coers

I joint two faces, rip other two faces 1/32 oversize, then thickness plane the sawn faces. Less sanding on planed and jointed faces than sawn. Are you going to taper the legs? Then it's to the bandsaw for that size of leg and cleaned up on the jointer.

Re: cutting square

#5

Re: cutting square

TomD

From the description I am having trouble understanding whether you are having trouble with the leg or the top, the end of the leg, or the sides?

Re: cutting square

#6

Re: cutting square

mike mcnerney

I know how to glue up a hollow leg like this & machine it square. It's when I cut it to length on the TS that does not go perfect, make a square cut, turn it over & do it again. It will show at the top where it meets the underside of the table if there is an irregularity.

Re: cutting square

#7

Re: cutting square

don stephan

Now I understand. The leg is 5 1/2" square so you have to cut from both sides to trim the leg to length, and the two crosscuts do not line up.

If using a miter fence (correct name?) and the cuts both begin on pencil line square all round, my guess would be the blade is not quite 90 degrees vertical. For this situation, I generally cut 1/8" long and then make a second pair of cuts to go through the wood without excessive friction on the blade.