Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Delta 28-180 bandsaw question

Posts

Delta 28-180 bandsaw question

#1

Delta 28-180 bandsaw question

Dan Bundy

Had to get replacement tires for my tabletop 8" delta bandsaw. The old tires were black and rubbery and had a bit of a crown to them. The new tires (from e-replacement parts) are yellow and more "Plasticy" (urethane?). The also appear to be flat on one side and a little bit concave on the other. Will it matter which side is out when they are stretched onto the wheel?

I know BS tires have some crown, so this threw me. I've had the saw for well over 10 years, but this is the first time the tires needed to be replaced. Thanks for any advice.

Re: Delta 28-180 bandsaw question

#2

Re: Delta 28-180 bandsaw question

del schisler

i belive you will be ok , just set the top wheel so that the band runs in the middle of the tire and do a reset of the guides and thrust beiring , and do a blade drift while you are at it , if you don't know about that post back i have done a few tire changes on different saws also good luck

Re: Delta 28-180 bandsaw question

#3

Re: Thanks!