Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Drying grown crooks?

Posts

Drying grown crooks?

#1

Drying grown crooks?

Keith Newton

I was trying to remember if we had discussed this here before, but an archives search didn't turn anything up. I know this is something out of the ordinary, but it could be a fun way to learn something new. I posted the following on sawing and drying forum, but I know some of you have mills and or drying experience that might find it interesting.

I have a White Oak log ready to saw that had a huge limb growing straight out that I'm planning to saw, with plans to utilize the crook for a table design that I'm working on.

I'm thinking I might sort of rough out the parts oversize before drying, which might reduce the chance for checking, over a larger mass.

However, I'm wondering if the physics of the 3 different axis of contraction will cause the curves to bend tighter as they contract, or straighten, or stay the same?

To my, thinking it probably will bend tighter. I was surprised to have the bend spring inward on some steam bent parts, that I was expecting springback from.

Do any of you have experience with this, or care to speculate?

I will plan on laying a square on each, and marking reference lines to monitor.

Re: Drying grown crooks?

#2

A Little

Mark Mandell - Gone Round In New Jersey

experience, but with crotch walnut that I've used to make cutting and cheese boards as gifts. My stuff stayed stable in the boards' cut plane (although did shrink in size) but noted the was more tendency to curl and cup, usually with the brand side moving up or down relative to the line of what was the trunk. Since I have my stuff milled to fat 5/4, it was easy to run through the P-Max and get a solid 1" flat.

FWIW

Re: Drying grown crooks?

#3

White oak is tough to dry

Dick Coers

I don't think you can minimize anything about white oak. Especially figured stock like that. It's going to crack, and crack for a long time. Maybe if you had a vacuum kiln, but they don't like differences in density, so even they would not work that well.