Re: Need a Girl's bed design.....
Grant in Iowa
Solid white oak, mortise and "lazy" tenoned, oak side rails, still in use ten years later. Like a tank.
My then about 14 year old daughter showed me a similar design in a magazine, then asked "could you make the top of the head board and foot board curved? Sure, I said, then the head scratching began.
I ended up with classic shouldered M&T on all of the main components, then cheated when I made the slats. Each slat is shouldered where it meets the bottom rail with 5/16" tenons, then the overall size of the slat was made 3/8" wide, so it would fit in to a 3/8" tenon in to the curved rail without cutting each shoulder individually. The mortises were sunk in the upper rail while the board was still straight for simplicity, and the center ones are still around an inch deep.
The curved top cap was accomplished in two parts. First, a layer of cove routed 1/2" thick oak was fastened to the top rail, then, a steam bent 3/4" piece was glued to the top of the first piece, then trimmed to length. I happened to have two badly bowed pieces that worked great. One could steam bend or just keep the bow gentle enough to work.
Side note is that my lovely daughter has now upgraded to a King, so this one sits in her guest bedroom. I get to sleep in it when we visit.
Doggie note: Neenah the doxie-poo is still around, although she now needs assistance to get on the bed.
Regards,
Grant in Iowa
