Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

All drawers are finally done

Posts

All drawers are finally done

#1

All drawers are finally done

Derek Cohen (in Perth, Australia)

Well, almost ...

The drawer bottoms have still to be made for 4 of the drawers. After making each one separately, it occurred to me that this was the one item that I could build en masse.



After the drawer bottoms are in, the task will be to make the drawer fronts coplanar. They are close to one another in curve, but there are a few variations here-and-there. What I plan to do is shim the drawers by about 1/2" to raise them out an equal amount so that they all lie proud of the carcase, place the chest on its back so that the drawers face upward, and then sand the faces with a long sander made out of a 2x4.

What do you think of this method? Any other ideas?

Regards from Perth

Derek

Re: All drawers are finally done

#2

Re: All drawers are finally done

Barry Irby

Start all over and get it right???? Just kidding. That looks fabulous.

I think you have a good idea. You could use a belt sand or even a ROS, but that would be dangerous. The 2x4 with really sharp sandpaper should do the job nicely. Might be able to use a cabinet scraper to ease the job.

Re: All drawers are finally done

#3

Beautiful job Derek!


Re: All drawers are finally done

#4

Adam of Oakland

Re: All drawers are finally done

Adam of Oakland

yep that is such a refined piece, really satisfying (vicariously) to see it coming together here -

I can't imagine any other way to get these drawerfronts flush with eachoter than doing it insitu using a long sanding block like you say. I could imagine there's a slight amount of clearance between the drawer sides and runners/kicks that might get annoying with the drawers wiggling back and forth with the sanding strokes.

if the sandpaper cuts really well then maybe it wont matter, but if the work was taking a lot of effort, i might build a supplemental pair of cauls running along the dovetails with 80g paper for grip. maybe some foam doublestick tape holding said paper to cauls just to allow for slight variances in width. I'd have to reposition the clamps to make room for my sanding...i guess it depends on how much wood needs to be removed.

Re: All drawers are finally done

#5

Re: All drawers are finally done

Derek Cohen (in Perth, Australia)

Thanks Adam

I've decided that what I will do is use the long sander with very fine sandpaper. It will simply mark the high spots on the drawers. Then these can be planed down - quicker and better finish than sandpaper.

I take the point of drawers moving. It had occurred to me. I plan to clamp/wedge them in position.

Regards from Perth

Derek

Re: All drawers are finally done

#6

Marking

Mark Mandell - Gone Round In New Jersey

If you give the fronts a coat of shellac your sanding beam will "dull" the high spots making them easier to see.

When the work's done you can easily rinse off the shellac with DNA.

BTW Make sure your 2x is dead-nuts straight ;)