Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Spray Guns

Posts

Spray Guns

#1

Spray Guns

David Frame

Good Morning All,

I'm in the market for a new spray gun. I presently own a Binks Model 7 and 2001 with various, needles, air, and fluid nozzles. I also own three inexpensive gravity feed spray guns. The largest fan I get from the Binks guns is about ten inches. Both Binks guns work fairly well, but I need better atomization. I've been looking into a C.A. Technologies CPR setup which has twelve holes in it's fluid nozzle to give what seems to be better for atomization. It's a low pressure, high volume gun. I'm not in the market for a gravity feed gun, but siphon cup or pressure pot feed spray gun. By the way, the type of spray gun I'm looking for will be used mainly for woodwork. However, I will also need it for metals and plastics.

The compressor I'm using is a an ancient 30 gallon Speedaire that works as if it were new. The volume it puts out is 9.1@ 40 psi and 7.1 CFM.

I would grateful for someone that can point me in the right direction, .

Thanks for your time,

David Frame

Re: Spray Guns

#2

Re: Spray Guns

Richard McComas

Call Jeff Hewitt at http://homesteadfinishingproducts.com/.

Re: Spray Guns

#3

Better atomization than a Binks 7?

Dick Coers

Ain't going to happen. You can get better efficiency, but not better atomization if that is really what you are after.

Re: Spray Guns

#4

Re: Better atomization than a Binks 7?

David Frame

Hi Mr. Coers,

Yes. There are spray guns that give better atomization. For instance, C.A. Technologies makes spray equipment with 12 holes in the fluid nozzle. It's called a CPR spray gun setup. It comes with 3 needles and 3 fluid nozzles. This gun needs high volume at low pressure. A company called Capasco in Lafayette, LA. allowed me to try it. From my experience, any Binks can't hold a candle to this C.A. Technologies CPR gun setup. I placed a down payment on it yesterday and the owners are allowing me to buy it on time without interest. I wasn't sure what spray gun to buy, but after going to Jeff Jewitt EBay site, he seems to lend himself towards selling Accuspray.

If you have a lot of spraying finishing to do, turbine guns are not the way to go. At least that has been my experience. when a turbine gun is used for a long time, the air gets quite warm and the medium being sprayed tends to come out more dry. I could be wrong though.

I've been using a Binks Model 7 and a 2001 for the past 25 years. They have served me well. But, after using the C.A. Technologies spray gun, I was sold on the CPR after a few minutes. It sprayed beautifully.

David Frame

Re: Spray Guns

#5

Re: Excellant Guns

Mark Mandell - Gone Round In New Jersey

The problem with the CPR series is that they require a lot of air, up to 14 SCFM which translates to a 3-5[real] hp, 100% duty cycle, stationary compressor. Few hobbyist woodworkers have that kind of air available.