Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Fixing an edge ding

Posts

Fixing an edge ding

#1

Fixing an edge ding

Bill Tindall, E.Tn.

This board was just long enough, wide enough and had proper grain for the feet of the chest of drawers I am building. But as I was preparing it for the feet I noticed a small gap where the edge didn't clean up from its rough state. A quarter round is going to sit on the top of this board but this dinged edge will show. I was motivated to use this piece of wood and tried something I have contemplated before.






I chiseled the ding so it had a flat smooth surface. Prepared a thin strip of cherry, slathered on some glue, let it dry a bit to be thicker and clamped it in place. Clamping was a challenge but I found an orientation that was successful. It worked.

Re: Fixing an edge ding

#2

Very satisfying....

John in NM

I love these kinds of fixes, aren't they positively fun to pull off successfully? :D

Re: Fixing an edge ding

#3

Re: Fixing an edge ding

William Duffield

If I can't fine a way to clamp a patch like your example, 3M blue tape works. It has enough stretch to put sufficient pressure on the joint, even if using yellow glue.

Re: Fixing an edge ding

#5

Kneale Brownson

Re: Fixing an edge ding

Kneale Brownson

Since I'm a klutz, I'm often trying to fix such issues, and can verify that painter tape can hold the glued-on bit sufficiently for the glue to cure so the fix can be completed.


img

Re: Fixing an edge ding

#6

Re: that would have been a better idea

William Duffield

If I'm using yellow glue, and making a large patch, or a structural repair, the blue tape may not apply enough pressure to get a good bond. If I couldn't get a clamp properly applied in a case like that, I would probably go to the extra trouble and curing time of liquid hide glue or even epoxy.

Re: Fixing an edge ding

#7

Ellis Walentine

We call 'em "Dutchmen"

Ellis Walentine

I can't think of many projects that don't end up needing a little patching here or there. For edge patches, I agree with the painter's tape clamping routine. This is a common approach when installing purfling around edges of things.

Krenov didn't abide patching at all. I once heard him compare it to "covering mistakes like a cat covers his droppings in a litter box." Struck me as funny.

Ellis

Re: Fixing an edge ding

#8

Steaming?

Derek Cohen (in Perth, Australia)

Hi Bill

Was this a hole or a ding? A hole needs filling (and I think you did a super job), but if it was a ding, did you consider steaming it out?

I wrote a short description of this on my website not so long ago:

http://www.inthewoodshop.com/Furniture/DentRemoval.html

Here is the ding needing work ..


Wetting first and then steaming with a wet rag ...


A light scraping and this is the result ...


Regards from Perth

Derek

Re: Fixing an edge ding

#9

Steaming with a Weller soldering iorn

Bill Tindall, E.Tn.

I don't know if they are still made but one of the Weller soldering irons that looks like a black pistol is ideal for steaming. The tip heats quick and hot. I keep one at hand and inside its case is some old fashioned lead solder (for soldering) and a cotton rag for steaming. As long as the grain isn't torn or missing steam typically saves the day.