Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Four down, four to go ..

Posts

Four down, four to go ..

#1

Four down, four to go ..

Derek Cohen (in Perth, Australia)

Just a quick update on the Lingerie Chest.

Four drawers done. They take 3 full days each to build (1 1/2 weekends). This includes thicknessing/sawing/shaping all the parts, dovetailing, and fitting.

The gaps between the drawers will be sorted out once all are done. There will be 1/16" between the drawers.



And the obligatory dovetail shot :)

The dovetails increase progressively, as with the size of the drawers.


Next post will be after all the drawers are done.

Regards from Perth

Derek

Re: Four down, four to go ..

#2

Question

David Yoho

Nice looking work, Derek. Looking at the dovetail shot, it looks like the drawer fronts extend below the drawer box and perhaps slides in against the drawer dividers acting as a stop. Is that correct? I've never seen that done before but think it's a cool idea if that's what it does.

Re: Four down, four to go ..

#3

Re: Question

Derek Cohen (in Perth, Australia)

Hi David

That is correct - the lip under the drawers do double duty. They minimise any breaks in the drawer fronts (although there will be a 1/16" gap, otherwise it will be too busy), and this also acts as a drawer stop. It does make for a little more to do, however. There is an article on my website detailing the process: http://www.inthewoodshop.com/Furniture/BuildingTheDrawers.html

Regards from Perth

Derek

Re: Four down, four to go ..

#4

Hmmmm?

Barry Irby

I realize this is a lingerie chest and will be lightly loaded, but how will using the drawer fronts as integral stops hold up in the Long run? Will closing the drawers repeatedly tend to bang the sides out of the dovetails? Doesn't look like its likely to crack the fronts, but maybe they are thinner than they appear.

Its a beautiful piece of work and cutting those DT's is way above my pay grade. Thanks for posting.

Re: Four down, four to go ..

#5

Re: Hmmmm?

Derek Cohen (in Perth, Australia)

Thanks for the thoughts, Barry.

I had planned on placing a very thin rubber or leather cushion between the stop and the drawer blade, more for the noise than protection (I don't want my lady love waking me up from a exciting dream by opening and closing drawers!). As it is, I have made a lot of similar Jarrah drawers and they have not shown any signs of wear-and-tear.

Regards from Perth

Derek

Re: Four down, four to go ..

#6

Selling by the pound?

Dick Coers

My brother used to constantly harass me about the weight of my furniture. When lifting and moving the big pieces, it was his repeated comment. I thought of him when I saw the thickness of the drawer fronts. Robert has been gone almost 8 years now, nice to have a mental jog in my memories of him.

Did you go thick to handle the stopping function?

Re: Four down, four to go ..

#7

Re: Selling by the pound?

Derek Cohen (in Perth, Australia)

Hi Dick

The drawer fronts are not thick. They are 22mm. The drawer sides are 8.5mm thick. These are typical measurements for 18th Century British drawers.

I think that the drawer fronts just look thicker because of the lower lip.

Regards from Perth

Derek