Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Roughsawn Curly Cherry

Posts

Roughsawn Curly Cherry

#1

Roughsawn Curly Cherry

don stephan

Another friend has expressed interest a large expanding curly cherry dining table top. If he proceeds I will include a spiral cutterhead for my planer in the proposal.

Recently all the cherry projects I've been asked to build have used rift and quartered cherry. I'm guessing that his source of curly cherry will all be flatsawn. Can anyone share experience on relative flatness of flatsawn curly and (plain) rift and quartered cherry?

Re: Roughsawn Curly Cherry

#2

Re: Roughsawn Curly Cherry

Dick Coers

That's going to vary with the size of tree, width of boards, and quality of kiln operator. I couldn't evenguess at an answer.

Re: Roughsawn Curly Cherry

#3

a perspective on the question

Bill Tindall, E.Tn.

Logs that are sawed to yield the best value, which includes 99.999+% of all the logs sawed, will produce lumber with a combination of flat to rift to quartered grain orientation. It is likely the curly cherry will be sawed this way. Essentially everything that is built from cherry is successfully built from this lumber. You should expect to do as well.

Cherry sapwood shrinks more than heartwood. A board with sap on one side and heart on the other often dries in the shape of a trough, though the best kiln practices lessen this problem.

BTW, I have never had any problem planing figured cherry with a planer with straight knives.

Re: Roughsawn Curly Cherry

#4

Re: Roughsawn Curly Cherry

Larry Clinton At Frankfort, (Central) Indiana

I have a pretty large supply of cherry in my hoard. I purchased one lot at an estate auction. It consisted of Two 4' X 4' skids with one tree stacked on them about 4 ~ 5 foot high. This was all Curly cherry (un-beknown to me until I had cleaned some up in my shop). This appeared to be several years old (very dirty) and was air dried, rough sawn with a few sacks of concrete weighing down the stack.The stock appears to be a mix flat, rift and quarter sawn. None of the 8' boards appear to be warped or twisted very much at all.

I also have several 10 ~ 12' long boards (rough sawn) about 12 ~16" wide that were kiln dried, again these do not exhibit any measurable cupping, warp or twist. All of this stock is in my shop which has heat / AC 24-7.

I do agree with Bill that cherry is pretty easy to plane, although I do have a Byrd head on my 20" planer now, and can't recall if any of the Cherry had tear-out when planed with my old DeWalt Benchtop.

Re: Roughsawn Curly Cherry

#5

Re: Roughsawn Curly Cherry

Keith Newton

Working it is fine, but when it comes time to finish it, you should use a wash-coat before staining, because it can turn blotchy without it.