Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Router Table Top

Posts

Router Table Top

#1

Router Table Top

Doug Reynolds

I got a new router lift which requires a new top for my router table. I have a sheet of 3/4" phenolic which I can use for the existing small opening that has lots of support on all four sides. Is 3/4" thick enough or, should I laminate two 3/4" pieces of Baltic birch plywood? Seems all the manufactured tops are at least 1 1/2" thick. The lift will hold a Bosch 1617 which is not huge in itself.

Happy Holidays

Re: Router Table Top

#2

Re: Router Table Top

Mark Mandell - Gone Round In New Jersey

Made mine with 3/4" MDF laminated both sides with mica. The router opening (9x12") is 3/8 phenolitic with adjusters threaded into each corner.

Still dead flat after 15 years holding a 3hp Ryobi

Re: Router Table Top

#3

Re: Router Table Top

John in NM

I've found the advantage of thick is for absorbing sound/vibration more than maintaining flatness. An inch and a half is certainly great for a router table top, but I wouldn't say its required.

Re: Router Table Top

#4

Re: Router Table Top

Jim Dillon

Doug, Happy Holidays to you too. I've had my Porter Cable 7518 (14.5 pounds according to Amazon) suspended from non-laminated 3/4-inch MDF for 20 years with no obvious sign of deflection. To be clear, the MDF was placed on ordinary 1x4s on edge along the table circumference and surrounding the plastic router opening. I guess it is like one-half of a torsion box.

To digress a bit. I built my router table into my TS extension table which is a real space saver. The only problem I have had was accidentally placing some very wet pressure treated lumber on the MDF for several days. When I lifted the lumber, I discovered the moisture had swollen the MDF slightly. The MDF had been coated with multiple coats of Watco. After a month or so, it had shrunk a bit and is usable but not like it was. The router table portion was OK. Your phenolic laminate should work well. I made my bandsaw table from the stuff and it is really nice. Good luck. Jim