Screw size question......
Barry Irby
I buy machine screws fairly often. No. 4, 6, 8, and 10's. The question is, What does the number stand for? Is it 1/32's of an inch? Seems like I should know this.
Knowledge You Can Build On — Est. 1998
Screw size question......
Barry Irby
I buy machine screws fairly often. No. 4, 6, 8, and 10's. The question is, What does the number stand for? Is it 1/32's of an inch? Seems like I should know this.
Re: Screw size question......
John K Jordan
Here's a formula:
Diameter=(number)*.013"+.060"
for example,
a number 4 screw has a diameter of 4*.013+.060 = .112"
a number 10 screw has a diameter of 10*.013+.06 = .190
JKJ
Re: Screw size question......
Kevin French
What is the significance *.013 and +.060
Re: Screw size question......
Barry Irby
No wonder I did not know this. How did you know? Who thought of this? After I posted the question I went to google and looked up the diameters, but would never have gotten to that formula. Seems like a doeh! moment to me.
Re: Screw size question......
John in NM
0.060" is a 0 screw - used to be the smallest one.
A 5 screw is 0.125". 0.0130" is one fifth of the difference between them.
Whoda thunk it?
Ellis Walentine
Not me.
Thanks for my tidbit of the day.
Ellis
Re: Screw size question......
ChuckinND
I guess that the information helps if your a machinist, I'm not, and still don't understand the equations. So because I'm not that smart, whenever I have to drill a hole for small machine screws I grab the drill index gauge to figure out what fraction of an inch that I need to drill, such as 1-16", 1/8", etc.
Re: Screw size question......
John K Jordan
>I guess that the information helps if your a machinist,
I doubt that, but it might help if you're a historian.
My guess is this was someone's idea to put real numbers on what I understand used to be a kind of haphazard rule of thumb based on the diameter of the head of the screw. Perhaps driven by the need for standardization for mass production?
Me, I keep good charts for drill sizes tapping to 60%/75% and for clearance holes for all the imperial and metric machine screw and bolt sizes.
JKJ
Re: Screw size question......
Jesse Cloud
Yeh, the equation isn't elegant, kinda arbitrary, probably backfitted to some conventions that already existed.
The good news is that there actually is a standard.
Wouldn't it be grand if we could go to the big box and know that a given size of plywood would still be the same thickness as the last time we bought it!!
Re: Screw size question......
John in NM
"Wouldn't it be grand if we could go to the big box and know that a given size of plywood would still be the same thickness as the last time we bought it!!"
Yikes! What a thought! 
Re: Screw size question......
Johanna Johanson
Dream on, Jesse!