That Ogee I asked about
Joe in a Cleveland suburb
Remember a couple weeks ago I asked how to create a specific profile? I wasn't too sure what it was even called. An Ogee it turns out (Thanks Barry Irby).
Wish I would have paid attention in math class and geometry.
Well, below is what I ended up with. Just a simple, cheap project.
It will probably end up on the porch next summer with plants on it. 
That's ok.
1.) The ogee on posterboard
2.) Getting read to cut the legs out
3.) Cut cut cut...
4.) Shoot the sawn edge
4.) Lay out my profile then cut'em out
5.) Clean up with a card scraper (and some sand paper)
6.) I was happy how they turned out. Probably will never remember how I did it... 
7.) Dados in the top to accept the legs
8.) Glue and (good old fashioned) screws. The screws were re-purposed from and old antique
9.) Done
10.) The brackets may be a little fat, but that's fine




