Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Seat tenons?

Posts

Seat tenons?

#1

Seat tenons?

Mark Mandell - Gone Round In New Jersey

DIL has requested one of these Green & Green Bandini benches


Being as it's a storage type of deal with the seats being up and down (probably harder that I wish with kids), and seeing as how I'm wingin' it on measurements, the question is:

The two "breadboard" seats are made with 4 pieces 4" wide that will be pinned M&T in the 2" side rails, so how deep would you cut the slot mortises for what length tenons?

I'm tending toward 3/4" to maintain some rigidity in the rails. Tenons will be 3/8" thick in 15/16" finished stock.

TIA

Re: Seat tenons?

#2

Re: Seat tenons?

Bill Tindall, E.Tn.

Your proposal seems adequate. I don't see much stress on the seat M&T's. If it was a door I would suggest something deeper.

Re: Seat tenons?

#3

Re: Seat tenons? *LINK*

Bob Lang

That's actually the entry hall bench from the Blacker House designed by Greene & Greene. Typically for those breadboard ends I run a tongue and groove about 1/2" deep and make the tenons as long as I can. 3/4" sounds short to me, but if it's 3/4" beyond the tongue it should be OK. I would go a bit farther, as those rails are wider than 2". With the rails at 2 1/2" wide I would make the tenons 1 5/8" or 1 3/4".

There are drawings for that bench in my book "Shop Drawings for Greene & Greene Furniture", which you can get directly from me . I also have large format plans available for that bench.

Sorry for the shameless self promotion, you can get most of my books directly from me at my website.

Bob Lang


ReadWatchDo.com

Re: Seat tenons?

#4

Thanks, Bob

Mark Mandell - Gone Round In New Jersey

but I don't buy plans.

Everything I make is a function, to some degree, of my own view and design of the original.

Mere replication of another's work holds no interest for me.

Piece