Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Out-dated Lacquer

Posts

Out-dated Lacquer

#1

Out-dated Lacquer

Chuck Jurvelin

This is directed towards Bill Tindall or anyone who can give me a definitive answer. I have about a 1/2 gallon of Sherwin Wms Hi-Build Precat Lacquer that is several months past the supposed shelf life. I decided to try it on some stain samples I had and it dried and looked perfect. So I decided to use it on the drawers and bottoms of the tabletops. I don't plan to use it on the primary surfaces, but I am curious what the possible problems could arise with its use. Thanks for any info you can share.

Re: Out-dated Lacquer

#2

Re: Out-dated Lacquer

Sgian Dubh

If it cures hard, it's still good to use. I've used pre-cat which the use by date indicates should have been used two or three years previously without any problems. If you're ever unsure, do a test spray on scrap to ascertain the viability of an out of date finish. There are usually obvious indications that a finish product is no longer good, e.g., thick, gloopy looking, or won't cure properly, or cures with an odd sheen, tinge, or other fault.

Sometimes it's a good decision to simply buy a new tin of whatever finish you need, and use that, disposing of the suspect finish in an appropriate manner. I say this because generally the cost of a reliably good finish far outweighs the risk of spoiling a project you may have hours working on, and significant expense on other materials, e.g., wood, board, hardware, etc. Slainte.

Re: Out-dated Lacquer

#3

Re: Out-dated Lacquer *LINK*

Dick Coers

"Even though these products are catalyzed at a much lower level than the post-cats, they do contain a catalyst and over time the chemical reaction (crosslinking) can occur in the can. How long the product will continue to perform as expected depends somewhat on the storage temperature (heat accelerates the chemical reaction). The partially crosslinked liquid might still spray, flow and dry well, but might not fully develop the properties desired. Adhesion between coats could be compromised and, without destructive testing, this can go unobserved. There is the increased possibility of cracking of the film with material used past its performance life."


http://www.woodshopnews.com/columns-blogs/finishing/502753-pre-cat-lacquers-become-the-new-standard

Re: Out-dated Lacquer

#4

Re: Out-dated Lacquer

Bill Tindall, E.Tn.

It goes "bad" by curing in the can which leads to thickening. If not too thick to spray it is useable. The use by date Is just an estimate of how long it takes to get too thick to spray which is highly temperature dependent.