Fiddleback finishing question
JL
I lucked into a bit of soft maple w/ a lot of figure.
Anyway - it went through the planer okay. It appears to sand okay.
How do I finish it to preserve the chatoyance?
Knowledge You Can Build On — Est. 1998
Fiddleback finishing question
JL
I lucked into a bit of soft maple w/ a lot of figure.
Anyway - it went through the planer okay. It appears to sand okay.
How do I finish it to preserve the chatoyance?
Re: Fiddleback finishing question
Bill Tindall, E.Tn.
A bright finish or any kind will preserve the figure; a dull finish will subdue it. So, bright lacquer or varnish, or shellac will be approximately equivalent. Dany delustered finish will subdue and many (I would claim all) water based finish will be less attractive than the bright solvent based choices.
Re: Fiddleback finishing question
Kent B
Whatcha making with it?
Re: Fiddleback finishing question
Lee Schierer in McKean, PA
This box is finished with Deft Clear Lacquer.
Re: Fiddleback finishing question
Joe in a Cleveland suburb
Jeff Jewitt has an article in FWW that you might find helpful.
"Pop the Curl in Curly Maple"
Fine Woodworking #135
pp. 38 April 1, 1999
Re: Fiddleback finishing question
Derek Cohen (in Perth, Australia)
I cannot speak about Maple, but I have worked with Aussie fiddleback woods. My current favourite finish is Livos Ardvos Universal Wood Oil (3 or 4 coats) rubbed on, followed by Howards Wax-N-Feed. This pops the figure and leaves a silky finish.
The chair is Fiddleback Jarrah ...

Regards from Perth
Derek
One thing not to do,
Keith Newton
About 30 years ago, I had a guy doing some finishing for me that always sprayed the first lacquer sealer coat from too far away and too light for my liking. Everything he did seemed to have a really dead look. I think you need to really wet out the fiber to really get it to reflect from the cell walls.
Re: Fiddleback finishing question
JL
A cradle.
Re: Fiddleback finishing question
Kent B
If it was me, I would do this:
Very lightly dampen a bit of a cotton rag with BLO, and wipe it on - the thinnest possible application.
Come back tomorrow, and pad on a couple coats of 3/4# or 1# ultra pale shellac.
Come back tomorrow, and apply Waterlox.
The big thing is this: Waterlox [or others in that arena] are not full cure until 4+ weeks. No kiddies in contact until sometime after that. Once it is at full cure, it is non-toxic.
So - I would just carry on with the shellac- but that's just me. Non-toxic from the start. and easy to repair.