Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Demilune-veneering the skirt

Posts

Demilune-veneering the skirt

#1

Demilune-veneering the skirt

Bill Tindall, E.Tn.

Veneering the skirt


PIC 1 assembly


Somewhere under there is the veneer being glued to the skirt. I have a lot of clamps and add as many as will fit.

PIC 2 parts


The gluing sandwich consists of the caul, frugally sawed from the serpentine drawer waste, stiff rubber gasket material, a piece of paper to soak up glue and moisture, veneer and finally the skirt. The caul is sawed so that it is slightly flexible under clamp pressure to aid conformation around the skirt arc while applying lots of pressure. I use white glue. If is squeezes through the crotch veneer, something that usually happens with commercial veneer (mine I sawed) it will not affect subsequent staining. The Headley shop uses white glue exclusively for this kind of veneering. If it works for them its good for me.

Re: Demilune-veneering the skirt

#2

Re: Demilune-veneering the skirt

Jesse Cloud

Nice post. The veneer is indeed spectacular, just as you promised.

Great idea to use the flexible gasket material. I think I might just stop at the auto parts store today as I have a similar task coming up.

This demilune project thread is one of the best I have seen on any woodworking forum. Thanks for sharing.

Re: Demilune-veneering the skirt

#3

Re: Veneer

Mark Mandell - Gone Round In New Jersey

Since you saw your own veneer, do you use anything on it to make it more flexible? The few times I've applied home-made veneer to curved surfaces I've had to deal with what seemed to be fractured or ruptured grain on the face.

Re: Demilune-veneering the skirt

#4

Re: Demilune-veneering the skirt

Bill Tindall, E.Tn.

For me it is the least assured of success of any I have posted. Stuff that isn't rectangular is tough, for me at least. The leg joints will make or break me. I am taking a break from them now.

Re: Demilune-veneering the skirt

#5

It needs to be thin if bent much

Bill Tindall, E.Tn.

I sanded this veneer to about the same thickness as old fashioned veneer.....something around 0.030 estimated not measured. It is all stuck down and I don' t have any way to measure it now.

Re: Demilune-veneering the skirt

#6

Re: It needs to be thin if bent much

Jesse Cloud

There are a number of veneer softening products, most based on glycerin, that will temporarily (a few days) soften veneer, making it significantly easier and safer to bend.

Personally, I like to trim down even shop made veneer to 3/32 or so. Even here in the arid desert that thickness would bend nicely around a gentle curve such as the one on the demilune.

I did break down and use the softener on some veneer that had been rolled up in my shop for three years (had an accident shortly after I ordered it and got back to that project after a long regimen of physical therapy). It worked wonders!

Re: Demilune-veneering the skirt

#7

It needs to be thin

Bill Tindall, E.Tn.

0.072" crotch was too stiff to bend to the demilune radius (mine is a smaller table than typical). Straight grained bent but it would have required more fiddly clamping to counteract its stiffness.