Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Demilune -Band Sawing the skirt

Posts

Demilune -Band Sawing the skirt

#1

Demilune -Band Sawing the skirt

Bill Tindall, E.Tn.

Band sawing

I don’t get out much and I don’t have a band saw book so I don’t know how common it is for people to saw the way I do. I recently helped an experienced woodworker to saw a complex shape and he was bewildered by my technique. Klutz that I am about many things I can band saw to a line, leaving a profile that is easily smoothed to a fair curve. (note: PIC 1 is a test cut)

PIC 1


What I do will be familiar to turners who ride the bevel of their tool to aid control of the cut. I ride the back of the band saw blade against the kerf behind the teeth. I then pivot the work piece off this pivot point (the back edge of the bade) to control where the teeth are cutting. On an outside curve any error results in a cut drifting to the waste side of the line. If the cut drifts outside the line I back up a fraction of an inch, adjust the teeth location by pivoting off the back of the blade and resume cutting. For someone watching it looks like I am taking 4 steps forward and one step back as I progress around the curve.

PIC 2


The result is a curve that is easily smoothed with a hand plane, file, or coarse sand paper, something that will be described in more detail in a subsequent post. You can see in Picture 2 the black marks that result from the back edge of the blade rubbing on the kerf.

Re: Demilune -Band Sawing the skirt

#2

Re: Demilune -Band Sawing the skirt

Joe in a Cleveland suburb

Bill, you said in an early post:

"The wood behind the front legs will be poplar and require veneering after the skirt is assembled."

Looking at PIC 2 of this post, am I correct in assuming the walnut in the front will also be veneered?

Re: Demilune -Band Sawing the skirt

#4

Pivot point

Mark Hennebury

On a small radius like this you could mount your stock to a pivot on an plywood or particle board table top and swing it pass the blade, giving you a very clean and precise radius with very little cleanup.

Mark Hennebury

Re: Demilune -Band Sawing the skirt

#5

If it's round - yes...

David Yoho

I can't tell from the picture if Bill's making this round or it has a bit of an elliptical shape. If it is elliptical, which many are, that technique wouldn't work. I'm sure he will clarify.

Re: Demilune -Band Sawing the skirt

#6

It's round....but

Bill Tindall, E.Tn.

I have heard of the pivot point technique. It would be a faster way of making circles if one needed to make a lot of circles. But for onesies and twosies, being able to keep the teeth confined to the line is a quicker means to the end.

I might also add the importance of selecting a blade with few enough teeth to get a smooth arc. If tiny teeth load up with saw dust within the cut it becomes difficult control the direction of the cut. Teeth marks are very easy to plane, file or sand away. Waves resulting from meanders of the blade are not.