Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

hydraulic/bottle jack question

Posts

hydraulic/bottle jack question

#1

hydraulic/bottle jack question

Jerry Gibbs

I have a bottle jack that will not retract fully. It will extend. There is what looks like a fill hole half way up the side and a valve at the bottom. With the jack on its side and the cylinder almost in, I filled the jack with fluid, which looked low. This did not work. I also filled the jack with the cylinder fully extended and it looks like I over-filled it. I purged most of the fluid when I fully unscrewed the valve. Any help is appreciated. Jerry

Re: hydraulic/bottle jack question

#2

Re: hydraulic/bottle jack question

John K Jordan

Does it retract most of the way? No more even when applying significant down pressure?

All I have is my own experience with these which is certainly incomplete. I have disassembled and cleaned/repaired my own.

If it didn't retract at all I might suspect a clogged release valve. If it got stuck partially retracted I might suspect some obstruction, burr, etc. If applying significant down pressure (i.e. a big c-clamp) didn't lower it all the way I would be tempted to disassemble and examine the parts.

JKJ

Re: hydraulic/bottle jack question

#3

Is the shaft bent?


Re: hydraulic/bottle jack question

#4

Re: hydraulic/bottle jack question

Pete in Holland MI

If you filled the jacket reservoir with the cylinder extended, there's no place for the oil exiting the cylinder to go. With the jack in an upright position, fill only to the hole on the side of the jacket reservoir.