Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Using Plunge bits for Faux raised panel look in M

Posts

Using Plunge bits for Faux raised panel look in M

#1

Using Plunge bits for Faux raised panel look in M

Mark

Has anyone had any luck with this approach. I would like to make some simple, inexpensive,painted replacement kitchen cupboard doors for the cottage. The thought of setting up the rail and stile set and raised panel bit is not appealing for this project .

Lee valley has a 3/4" plunge bit..thought it might work?

Re: Using Plunge bits for Faux raised panel look in M

#2

Skip the router

Thomas Skaggs, Foothills of Mount Level

All you need is a scratch cutter for this and do it by hand. It's an old tried and true way to do faux beads. Here is a link to a Fine Woodworking article for making your own scratch stock.

T

http://www.finewoodworking.com/item/57331/how-to-make-a-scratch-stock-for-beading

Re: Using Plunge bits for Faux raised panel look in M

#3

Re: Using Plunge bits for Faux raised panel look i

Dick Coers

So you aw thinking about running the bottom of the bit on the face of the panel? You'll have a lot of circular lines to clean up if that's the direction you are going. I would cut out most of the stock, then set up a vertical router bit cut to clean up the saw marks.

Re: Using Plunge bits for Faux raised panel look in M

#4

Is that suppose to be MDF?

Keith Newton

You would do well to call around in your area to find a door shop, and just have them make some to match. The price is really not that bad in my area.

Re: Using Plunge bits for Faux raised panel look in M

#5

Re: Is that suppose to be MDF?

Mark

Yes MDF was what I was planning on using.

Idea was to set up a rectangular jig that would surround the door panel and with a plunge router and bit run the router around the jig , routing out the grove and leaving a 2.5 inch rail and stile effect around the door panel.

Re: Using Plunge bits for Faux raised panel look in M

#6

Re: Is that suppose to be MDF?

John in NM

I don't see any reason it shouldn't work from a technical point of view. It's always going to look like what it is though.

One thing you could try is routing more than one profile using your jig and some spacers. Start with the outer most groove that imitates the rail and stile edge, then step in 3/4" or so by adding spacer blocks to your jig and imitate the raised panel cut with a different bit.

This is just off the cuff of course, no idea which bits you'd need to use or what spacing would work.

Re: Using Plunge bits for Faux raised panel look in M

#7

Re: Using Plunge bits for Faux raised panel look i

mdclor

Mark, it might not be the look you are after, but you could just apply a rectangle of molding to the face of the MDF.