Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

new bearings in my table saw

Posts

new bearings in my table saw

#1

new bearings in my table saw

john lucas

I bought a used Grizzly cabinet saw about year ago. It seemed to work quite well, cuts were accurate. A little noisy compared to my Powermatic contractors saw but then it's 3hp and bigger. It broke a belt just before my move so I decided I'd take everything apart and clean it well and replace the belt after I got the new shop up.

Well the drive pully had the outside groove eaten off by the now broken belt. It didn't have any set screws in it and had slipped out of position. Having trouble finding a replacement from GRizzly because there's no model number on this saw. Anyway turned away the groove on my metal lathe and will run it with 2 belts until I can find a replacement.

While I was doing that I noticed a not very smooth upper pulley so decided to replace the bearings. Man what difference. That saw runs so smooth and quiet now. Wish I had done that after I got it.

Realigned the table and can't wait to test it on some critical work but it will be later in the month before I get the dust collector up and running so I don't want to cut any more than I have to right now to get the shop up. I did hook a shop vac up the saw but it needs more than that to really collect the dust.

Re: new bearings in my table saw

#2

Re: new bearings in my table saw

Ralph Lipeles

Can you give us the specs on the pulley? OD, Bore, belt size, etc.

Re: new bearings in my table saw

#3

Jim DeLaney, Austintown, Ohio

Re: new bearings in my table saw

Jim DeLaney, Austintown, Ohio

The Model 1023 was the most popular (common) Grizzly cabinet saw. Three gang sheave (pulley) with a 5/8" or 16mm bore. Measure carefully...

Grizz oughtta have it.

Re: new bearings in my table saw

#4

Re: new bearings in my table saw

john lucas

I didn't measure the shaft yet but the one on the motor which is the bad one has a hole that is at least 3/4" maybe 1".