Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

band saw bearing replacement

Posts

band saw bearing replacement

#1

band saw bearing replacement

ronald rimmer

I have an old Craftsman tilt head 12 in. band saw and the bearing has gone bad in the lower wheel. The bearings are not in the wheel but in the frame of the saw which appears to be aluminum and not real sturdy.

Has anyone here tried replacing the bearings in this saw or any saw,if so I would love to hear how to,and advice from you before I tear into this thing

Re: band saw bearing replacement

#2

Re: band saw bearing replacement

John K Jordan

I have no experience with this but when I typed "replace bearings in old tilt head craftsman 12" bandsaw" into Google a bunch of links were listed. Perhaps one of these would help.

Re: band saw bearing replacement

#3

Re: band saw bearing replacement

ronald rimmer

Thanks but I think I have been thru them all but I could have missed it.

Re: band saw bearing replacement

#4

Re: band saw bearing replacement

John K Jordan

Yes, there may not be much. I read through a few and all I found about bearings was this:

"Took the tilt head off the table (an ugly job) and found the hidden set screw for the driven pulley which felt a bit loose. Since I was so close I decided to remove the bearings ( The shaft and bearings and the bearings and housing are a press fit. Without a press I used a hammer) "

You might try posting on some of the other forums too, if you haven't (like sawmill creek).

JKJ

Re: band saw bearing replacement

#5

Re: band saw bearing replacement

TomD

Sometimes a threaded rod and some nuts is better than a hammer. That is essentially the very fancy tool they use for setting bearings in a bicycle headset. Actually a screw set, and a slide hammer set.

Re: band saw bearing replacement

#6

Re: bearing replacement

Mark Mandell - Gone Round In New Jersey

Actually, if you don't have a bearing press available (most any auto or machine shop will have one) a drill press might do you quite well. Caution here that all pressure be put on the inner race or you're likely to wreck the bearing.

Just went through this on my JET 18", Made a huge difference.

HUGE I tells ya!

Re: band saw bearing replacement

#7

Re: bearing replacement

Bill Turpin in WNC mountains

A socket of the same diameter as the bearing can make a good presser. Always press on the race under friction. Doing the opposite will scar your new bearings yielding quick failure.

Re: band saw bearing replacement

#8

Re: bearing replacement

ronald rimmer

Thanks everyone for the replies I've been thinking about using this as is till I can find a good used saw and then just chunking it, it's not a very good saw to begin with.

Re: band saw bearing replacement

#9

A Job

Mark Mandell - Gone Round In New Jersey

Ronald,

From what I've seen of that machine, the motor and drive pulley are on the opposite side of the frame from your lower band wheel. Thus it appears that you will have to remove the motor and the drive belt pulley before you can even start to get to the bearings. Get them off, then remove the large wheel and you'll be in position to remove the drive shaft. depending on design, it will remove from the front or the back and needs be pulled "through" a bearing on the opposite side. getting both bearings out is likely to be a fight, and there's no guaranty that their size/type markings will survive the effort.

I suggest you find info on and a source for the replacement bearings before you dive into this lest you wind up with just a bunch of parts on the floor and no saw.